Règles de sécurité pour les travailleurs en plongée
1.1 Généralités
1.1.1
Cette norme s'applique aux interventions sous-marines et définit les règles de
sécurité des travailleurs en plongée.
Note. Il est reconnu que certaines tâches devant être effectuées sou l'eau
peuvent demander des normes et des techniques spécialisées qui diffèrent des
exigences énoncées dans cette norme mais qui peuvent être acceptées par les
pouvoirs…
1.1
This Standard specifies performance requirements for factory-made dehumidifiers
having a rated daily water-removal capacity of up to 30 L (63.4 US pints).
Included are uniform procedures for measuring the
(a) capacity; and
(b) minimum energy factor (EF).
Note: The Committee has recommended an implementation date for EF of January 1,
1996.
1.2
The values given is SI (metric…
Methods of Testing Petroleum and Associated Products Standard Test Method for
the Identification o...
1.1
This test method is a standard procedure for the determination of paraffins,
oelfins, naphthenes, aromatics and unknowns (P.O.N.A.U.) in automotive gasolines
using gas chromatography.
1.2
Individual hydrocarbon components or groups of coelutIng components greater than
or equal to 0.01% by mass are determined.
1.3
The separation of individual hydrocarbons by the procedure described…
Medical electrical equipment - Part 1: General requirements for safety - 2. Collateral Standard: Ele...
This standard applies only to MEDICAL ELECTRICAL EQUIPMENT, MEDICAL ELECTRICAL
SYSTEMS, INFORMATION TECHNOLOGY EQUIPMENT used in medical electrical
application, and all other equipment forming part of MEDICAL ELECTRICAL
SYSTEMS, hereinafter referred to as EQUIPMENT and/or SYSTEMS designed to be
installed and used in accordance with the rules of the Canadian Electrical
Code, Part 1.
The…
1.1 General
This standard covers materials to be used and methods to be followed for the
manufacture, transportation, and erection of architectural, structural, and
specialty precast concrete products.
Notes:
(1) Good control over dimension, appearance, and performance of precast
concrete products can be obtained when this Standard is used.
(2) This Standard should be specified for…
Scope
1.1 General
This Guideline provides a method for conducting environmental life cycle
analysis and assessment. It guides industry formulation of product life cycle
process stages, stage screening and problem definition, inventory analysis, and
evaluation of environmental burdens for possible improvements.
This Guideline addresses the life cycle assessment (LCA) components…
Performance of Direct-Expansion (DX) Ground-Source Heat Pumps
1.1
This Standard is intended for the performance rating of factory-assembled
unitary heat pumps, that are intended for use in direct-expansion (DX)
ground-source heat pump systems.
1.2
Within the scope of the Standard, DX heat pumps are classified as
single-package or matching assemblies that utilize indoor air as the energy
sink on heating and the energy source on cooling, and a refrigerant as…
1.1
This Standard applies to all types of fume hoods.
1.2
This Standard specifies safety requirements for fume hoods and test methods to be used to determine performance.
1.3
This Standard provides recommendations for selection, use, user education and maintenance of fume hoods.
1.4
This Standard provides recommendations for necessary information to be exchanged between the supplier…
1.1
This Standard applies to the following plumbing fixtures:
(a) bathtubs;
(b) kitchen and bar sinks;
(c) lavatories;
(d) laundry tubs;
(e) shower enclosures and receptors;
(f) drinking fountains and water coolers;
(g) water closets;
(h) bidets;
(i) urinals;
(j) non-recirculating toilets and waste-holding tanks for use in recreational
vehicles; and
(k) self-contained, recirculating…
