Information technology - Telecommunications and information exchange between
systems - Local and me...
The international community has decided to make this standard available only
in the English language version. It has been adopted as a National Standard of
Canada on this basis.
This National Standard of Canada is equivalent to International Standard
ISO/IEC 15802-4:1994.
2. Scope
The System Load Protocol specification defines a protocol to load the memory of
data processing…
Information technology - Message Handling Systems (MHS) - Part 9: Electronic
Data Interchange Messa...
The international community has decided to make this standard available only in
the English language version. It has been adopted as a National Standard of
Canada on this basis.
This National Standard of Canada is equivalent to International Standard
ISO/IEC 10021-9:1995.
1 Scope
This part of ISO/IEC 10021 is one of a set of standards for message handling.
The entire set provides…
Information technology — Security techniques — Key management — Part 2: Mechanisms using symmetric t...
Defines key establishment mechanisms using symmetric cryptographic techniques. Addresses three environments for the establishment of keys: Point-to-Point, Key Distribution Centre (KDC) and Key Translation Centre (KTC). Describes the required content of messages which carry keying material or are necessary to set up the conditions under which the keying material can be established.
Information technology - Security techniques - Key management - Part 2: Mechanisms using symmetric t...
Defines key establishment mechanisms using symmetric cryptographic techniques. Addresses three environments for the establishment of keys: Point-to-Point, Key Distribution Centre (KDC) and Key Translation Centre (KTC). Describes the required content of messages which carry keying material or are necessary to set up the conditions under which the keying material can be established.
Electromagnetic compatibility (EMC) - Part 4: Testing and measurement techniques - Section 6: Immuni...
Relates to the conducted immunity requirements of electrical and electronic equipment to electromagnetic disturbances coming from intended radio-frequency (RF) transmitters in the frequency range 9 kHz up to 80 MHz. Equipment not having at least one conducting cable (such as mains supply, signal line or earth connection), which can couple the equipment to the disturbing RF fields is excluded.…
Methods of Sampling and Testing Tobacco
Determination of Benzo[a]pyrene in Total Particulate Matter...
1. SCOPe
1.1 This method is used to isolate and to determine the benzo[a]pyrene
(B[a]P) content in total particulate matter (TPM) of tobacco smoke.
1.2 The testing and evaluation of a product against this method may
require the use of materials and/or equipment that could be hazardous.
This document does not purport to address all the safety aspects…
Equipment reliability testing - Part 3: Preferred test conditions - Section 5: Test cycle 5: Ground ...
Applies to direct current (d.c.) powered mobile equipment. The
equipment is operated while being transported, for example in or on
a vehicle but does not form part of the vehicle, and is not
designed to be installed permanently in a vehicle. The equipment
experiences general open-air climates according to IEC 60721-2-1.
The degree of simulation of this test cycle is low.
The contents of the…
Iron ores — Determination of cobalt content — Flame atomic absorption spectrometric method
Specifies a flame atomic absorption spectrometric method for the determination of the cobalt content of iron ores. This method is applicable to a concentration range of 0,000 6 % (m/m) to 0,070 0 % (m/m) of cobalt in natural iron ores, iron ore concentrates and agglomerates, including sinter products.
Specifies a gravimetric method for the determination of nickel content of nickel oxide and partially reduced nickel oxide in the range of 70 % to 95 % (m/m).
