Lever switches. Part 1: General requirements and rules for the preparation of detail specifications
Applies to lever switches for use in electronic and electromechanical equipment, including switches necessary to connect the supply mains. Switches covered by this standard have a maximum rated voltage not exceeding 500 V and a maximum rated current not exceeding 25 A (d.c. or a.c. r.m.s. values).
Establishes uniform specifications and type test requirements for lever switches also establish…
Safety of household and similar electrical appliances - Part 2: Particular requirements for commerci...
Deals with the safety of electrically operated commercial forced convection ovens, steam cookers, steam-convection ovens and, exclusive of any other use, steam generators, not intended for household use, their rated voltage being not more than 250 V for single-phase appliances connected between one phase and neutral and 480 V for other appliances.
Is to be used in conjunction with IEC 335-1 (…
Fire hazard testing. Part 2: Test methods. Bad-connection test with heaters
The bad-connection test with heaters is intended to simulate an overheated connection, consideration being given to the connection and to the current passing through it under normal conditions of use, in order to assess the fire hazard by a simulation technique. The test is to be applied only to screw connections.
Has the status of a basic safety publication in accordance with IEC Guide 104.…
Specification for flexible insulating sleeving. Part 2: Methods of test.
Gives methods of test for flexible insulating sleeving, including heat shrinkable sleeving intended primarily for insulating electrical conductors and connections of electrical apparatus.
Safety requirements for electronic flash apparatus for photographic purposes
Applies to the following electronic flash apparatus for photographic purposes, having a stored energy not exceeding 2 000 J, together with associated apparatus and not intended to be subjected to dripping or splashing: apparatus of the single flash type; apparatus for the illumination of sequential photographic exposures; battery chargers and supply units to be used in connection with electronic…
1. Scope
1.1 This standard describes the formats, rules, and procedures for the encoding of alphanumeric text and pictorial information for videotex and teletext¹ applications. (¹The term teletext (not yet adopted by CCIR) is commonly used to refer to a broadcast television videotex service. It is different from teletex, a term officially adopted by CCITT to define a specific type of…
1. Scope
1.1 This Standard applies to hand- or tool-applied pressure splicing wire and cable connectors intended for use with copper or aluminum, or both, insulated conductors in accordance with the Canadian Electrical Code, Part I.
1.2 The splicing wire and cable connectors are intended for use with any combination of the following conductors: Nos. 22 - 10 AWG solid and stranded…
Road vehicles — Base-mounted air compressors, single cylinder V-belt drive — Mounting dimensions
Specifies the dimensional requirements for interchangeability of base-mounted air compressors mounted on commercial vehicles and buses. A figure illustrates shapes and reference quantities of concern. Includes dimensions and tolerances for types 1a, 1b, 2a, 2b, as well as pipe connections with idenfication codes as follows: 0, 2, 81, 82, 91, 92.
Aircraft — 2 and 3A plug-in base change-over relays, Type II, with crimped connections — Clearance a...
Lays down the dimensions and specifies the fixing and the designations of these relays. The characteristics and performance requirements will be specified in forthcoming International Standards. Includes definition, dimensions of two pole and four pole relays, arrangement of terminals of bases and dimensions after coupling the contacts, holes in the support, connections for crimping and…