1.1
This Standard covers structural quality steel plates, shapes, hollow sections,
sheet piling, and bars for general construction and engineering purposes.
1.2
A number of strength levels are available under this Standard and are
designated by the minimum yield strength in ksi. The grades, types, and
strength levels normally available are shown in Table 1. Charpy V-Notch
categories…
Implants for surgery — Metal bone screws with hexagonal drive connection, spherical under-surface of...
Gives dimensions and tolerances and the code for screw thread. Screws with shallow thread shall be as given in figures 1 and 2 and tables 1 and 2. Screws with deep thread shall be as given in figures 3 and 4 and tables 3 and 4. Marking and packaging shall be in accordance with ISO 6018. An example for combined screw is given in annex A. An interrelationship of International Standards dealing with…
Rock drilling equipment — Drill rods with tapered connection for percussive drilling
Lays down the basic dimensions of drill rods and the necessary dimensions of the tapered connections. These dimensions shall comply with those given in figure 1 and table 1 and in figure 2 and table 2, respectively.
Welding of Reinforcing Bars in Reinforced Concrete Construction
1. Scope
1.1 This Standard applies to
(a) the design, fabrication, and inspection of welded connections utilizing deformed reinforcing bars and to the certification of companies involved in such work;
(b) welding of deformed reinforcing bars (except for pre- stressing steel or for bar or rod mats for which the welding is covered by the manufacturing specification) either directly…
1. Scope
1.1 This Standard applies to single or multiple conductor, round, flat, or coiled appliance wiring material products for use as follows:
(a) Class I Internal: Group (A) - where not subjected to mechanical abuse. Group (B) - where may be subjected to mechanical abuse. (1) Wet (2) Oil; and
(b) Class II External: Group (A) - where not subjected to mechanical abuse. Group (B) -…
Passenger cars — Wiper systems — Shaft ends and arm-holes
Specifies the main dimensions and general requirements for wiper arm to shaft end connections of wiper systems. Gives the preferred type 1; the normative annex A includes the non-preferred type 2.
Specifies the basic dimensions and access clearance. The basic dimensions shall be as specified in figure 1. The clearance allowed around the connector shall be in accordance with figure 2.
Connectors for frequencies below 3 MHz for use with printed boards. Part 8: Two-part connectors for ...
Applies to a group of related two-part connectors for printed boards for board-to-board and board-to-wire connection, with tin or gold plated contact area according to the style. The free or fixed board-mounted connectors are provided with terminations suitable for printed boards in accordance with IEC 60326 and using a grid of 2.54 mm (0.1 in) as laid down in IEC 60097.
