Rechercher

This standard defines the immunity test methods and range of preferred test levels for electrical and electronic equipment connected to low voltage power supply networks for voltages dips, short interruptions, and voltage variations. It applies to electrical and electronic equipment having a rated input current not exceeding 16 A per phase. It does not apply to electrical and electronic equipment…

Cette norme a pour but de définir les méthodes d'essai d'immunité et les gammes des niveaux d'essais conseillées pour les équipements électriques et électroniques connectés aux réseaux basse tension, en ce qui concerne les creux de tension et les coupures brèves et les variations de tension. Elle s'applique à des équipements électriques et électroniques dont le courant d'…

Specifies general (pressure, temperature, designation, assembly, marking) and dimensional requirements for the design and performance of 24° compression fittings which are suitable for use with ferrous and non-ferrous tubes with outside diameters from 4 mm to 42 mm, inclusive. These fittings are for use in fluid power and general applications within the limits of pressure and temperature…

ISO/IEC ISP 10608 is applicable to end systems concerned with operating in the open systems interconnection (OSI) environment. It specifies a combination of OSI standards which collectively provide the connection-mode transport service using the connectionless network service. This part is applicable to the provision of the connection-mode transport service in end systems attached to a token ring…

Is applicable to end systems or relay systems operating over token ring LAN subnetworks in the open systems interconnection (OSI) environment. Relates to any of the transport (Tx, Ux) or relay (Rx) profiles defined in ISO/IEC TR 10000-2, where such profile uses subnetwork type 53. Specifically, provides a common set of requirements that are applicable to transport groups TA, TB, TC, TD, TE, UA,…

1.1 This standard applies to asbestos-cement, nonpressure, small-diameter pipe, suitable for use as building sewer pipe and as building drain pipe buried under the floor. 1.2 For cautionary notes on cutting, sanding, grinding or drilling of this product, see par. 6.2.2 and 8.3.

This National Standard of Canada is based on International Standard IEC 1010-2-031:1993. 1. Scope and Object This clause of part 1 is applicable except as follows: 1.1 Scope Replacement: This Particular Standard specifies requirements for the safety of hand-held and hand-manipulated probe assemblies designed to be used with equipment installed and used in accordance with the Rules…

Gives complete general and dimensional specifications. For flange connections, a minimum design factor of 2,5 is valid with screws of property class 8.8, not including weld joints, for which special instructions exist. The design factor of the flange may be increased to 3,5 or better by using flange-head screws of property class 10.9. Also includes appropriate references to the O-ring seals and…

Gives complete general and dimensional specifications. For flange connections, a design factor of 2,5 is valid, not including weld joints, for which special instructions exist. Also specifies the dimensions of the seals to be used, as well as the grooves to house the seals.