Information technology - Microprocessor systems - Futurebus+ - Logical protocol specification
Specifies the logical layer for a set of signal lines that constitute a multiple segment bus architecture, and for the interfacing of modules connected to a bus segment. Intended to be used as a component within a profile to build systems with higher levels of compatibility.
Commercial vehicles with 24 V systems — 15-pole connectors between towing vehicles and trailers — Di...
Specifies dimensions and specific requirements for the 15-pole connector and its contact allocation to enable electrical connection between commercial towing vehicles and their trailers equipped with 24 V systems to be made and to ensure interchangeability. Further specifies a park socket used to receive and store the plug when it is disconnected. Annex A specifies characteristics of two adaptors…
Electromagnetic compatibility (EMC) - Part 3: Limits - Section 3: Limitation of voltage fluctuations...
This section of IEC 61000-3 is concerned with the limitation of voltage fluctuations and flicker impressed on the public low-voltage system. It specifies limits of voltage changes which may be produced by an equipment tested under specified conditions and gives guidance on methods of assessment. This section is applicable to electrical and electronic equipment having an input current up to and…
1. Scope
1.1
This Standard prescribes the minimum requirements for telecommunications
premise wiring systems installed within the family units of a building that is
used primarily for residential use (single-family, multi-occupant, or
multi-unit). The installation of the wiring is to be used in accordance with
the Rules of the Canadian Electrical Code, Part 1. The wiring system is to be…
Grounding and Bonding for Telecommunications in Commercial Buildings
2 Scope
2.1 General
2.1.1 This Standard specifies the requirements for a uniform
telecommunications grounding and bonding infrastructure that shall be followed
within commercial buildings where telecommunications equipment is intended to
be installed.
2.1.2 This telecommunications grounding and bonding infrastructure in
conjunction with other grounding and bonding systems (e.g.,…
Information technology - Telecommunications and information exchange between systems - Private Inter...
The international community has decided to make this standard available only in
the English language version. It has been adopted as a National Standard of
Canada on this basis.
This National Standard of Canada is equivalent to International Standard
ISO/IEC 11572:1994.
1 Scope
This International Standard defines the signalling procedures and protocol for
the purpose of circuit-…
Aircraft — Connections for checking hydraulic systems by ground appliances — Threaded type
Cancels and replaces the first edition (1981). Specifies the requirements for connections installed in aircraft hydraulic system pressure and suction lines, intended for checking the systems by means of ground appliances.
Laryngoscopic fittings — Part 1: Conventional hook-on type handle-blade fittings
Cancels and replaces the first edition (1984). Lays down critical dimensions and considerations for the junction of any blade and any handle of a hook-on type laryngoscope to allow engagement, lamp illumination and disengagement through multiple cycles. Does not cover: the blade form or handle design other than the interchangeability aspects of the connection between the blade and the handle; the…
Floor, Area, and Shower Drains, and Cleanouts for Residential Construction
1.1
This Standard includes requirements for floor, area, and shower drains, and
floor cleanouts that are used in residential construction, as defined in Part 9
of the National Building Code of Canada (NBCC).
1.2
This Standard includes requirements for materials, outlet connections,
integral traps, and tests for top loading, water tightness of backwater valves
and cleanouts, and…
