Rechercher

This International Standard applies to physical connectors and cables, electrical properties, and logical protocols for point-to-point serial scalable interconnect, operating at speeds of 10 Mbit/s to 200 Mbit/s and at 1 Gbit/s in copper and optic technologies (as developed in Open Microprocessor Systems Initiative/Heterogeneous InterConnect Project (OMI/HIC)). The object of this International…

The construction of high-performance systems with parallel communications, parallel processing, and/or parallel I/O demands a fast, low-cost, low-latency interconnect. It must be fast and low-latency, otherwise it will be the limiting factor in system performance; and it must be low-cost, or it will dominate the system cost. This standard has been developed to complement recent technical…

SBus is a high performance computer I/O interface for connecting integrated circuits and SBus Cards to a computer system motherboard. This standard defines the mechanical, electrical, environmental, and protocol requirements for the design of SBus Cards and the computer system motherboard that supports those cards. Every SBus Card shall implement appropriate self-descriptive and initialization…

1. Scope 1.1 These requirements apply to factory-built chimney connectors and wall pass-through assemblies that do not require field fabrication. They are for use with gas, liquid and solid-fuel-fired residential appliances and building heating equipment where the flue-gas temperatures do not normally exceed 650ºC. Factory-built chimney connectors are intended for use inside buildings to form a…

This part of ISO 10333 specifies the requirements, test methods, instructions for general use, marking, packaging and maintenance for full-body harnesses (FBH). The main purpose of a FBH is to allow the user to connect into a personal fall-arrest system (PFAS), which will be specified in a future International Standard (see ISO 10333-6 in the Bibliography), such that if an arrest takes place, the…

An input/output expansion bus with a 32- or 64-bit width is described in this standard. The SBus is designed for systems requiring a small number expansion ports. SBus Cards may be connected to a standard Sbus Connector mounted on the motherboard. SBus Devices may also be attached to the SBus directly on the system's motherboard. The dimensions of the SBus Card are 83,8 mm by 146,7 mm,…

This ISO/IEC standard for FC-SW specifies tools and algorithms for interconnection and initialization of Fibre Channel switches to create a multi-switch Fibre Channel Fabric. This Standard defines an E_Port (ìExpansion Portî) that operates in a manner similar to an N_Port and F_Port, as defined in ISO/IEC 14165- 111, with additional functionality provided for interconnecting switches. This…

This part of ISO/TS 10811 defines methods of measurement, algorithms for analysis and the report of shock and vibration data for equipment in buildings which is sensitive to shock and vibration. The methods are applicable to the quantification of a future installation or the verification of an existing one. Accurate vibration data acquisition, analysis and uniform reporting methods are needed to…

This part of ISO/TS 10811 defines a method for the classification of shock and vibration in buildings from measurements in accordance with ISO/TS 10811-1. A classification system of environmental vibration conditions should serve as guidelines for designers, manufacturers and users of equipment sensitive to shock and vibration, and for building constructors. The types of shock and vibration…

This part of ISO 14230 specifies the requirements for the Keyword Protocol 2000 (KWP 2000) data link and connected vehicle and scan tool when used to comply with on-board diagnostic (OBD) requirements for emission-related test data. This part of ISO 14230 only specifies requirements relative to the Keyword Protocol 2000 for OBD purposes. Complete specification can be found in ISO 14230 parts 1 to…