Rechercher

Le présent document spécifie les dimensions d’interface pour l’interchangeabilité et spécifie les exigences de performance pour les raccords rapides hydrauliques de type à face plane pour usage à des pressions de 10 MPa (100 bar) à 31,5 MPa (315 bar), selon la dimension de raccordement. Les raccords conformes au présent document ne sont pas conçus pour être connectés ou déconnectés sous pression…

This document specifies the SAE J1939-based application layer, the payload of messages, and parameter groups for electronically controlled braking systems, including anti-lock braking systems (ABS), vehicle dynamics control systems (VDC), and running gears equipment, to ensure the interchange of digital information between road vehicles with a maximum authorized total mass greater than 3 500 kg…

IEC 61558-4-28:2023 provides a means of connecting devices through a partial mesh network, such that most failures of an interconnection between two devices can be circumvented. In common practice, the devices are interconnected in a non-redundant hierarchical manner reflecting application needs.

This document specifies a safety information system for tanks made by combining several elements onto a single marking to communicate health and hazard safety information and information in case of an emergency for the purpose of accident prevention. The organization's risk assessment will determine when and where this safety information system for tanks will be used. Possible applications…

1 Scope 1.1 General This Standard covers socket- and saddle-type polyethylene (PE) electrofusion fittings that are used to join PE pipe where the heat source is an integral part of the fitting. Note: Fittings covered by this Standard are connected to an electrical power source during the fusion process. Power sources, cables, and electrical connections are covered by the Canadian Electrical…

1 Scope 1.1 General This Standard covers polyethylene (PE) pipe, tubing, and fittings for use in gas mains and services, including gathering, transmission, and distribution of fuel gases containing not more than 1% aromatic hydrocarbons. 1.2 Fittings and connections This Standard covers all types of fittings and connections used in plastic gas pipe systems, including a) plastic-to-metal…

1 Scope 1.1 General This Standard covers polyamide (PA) pipe, tubing, and fittings for use in gas mains and services, including the gathering, transmission, and distribution of gases that can contain aromatic hydrocarbons. 1.2 Fittings and connections This Standard covers all types of fittings and connections used in PA piping systems for gas services, including plastic-to-metal transition…

Scope Replacement: This part of IEC 60601 applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of SURGICAL LUMINAIRES and LUMINAIRES FOR DIAGNOSIS, hereafter referred to as ME EQUIPMENT. If a clause or subclause is specifically intended to be applicable to ME EQUIPMENT only, or to ME SYSTEMS only, the title and content of that clause or subclause will say so. If that is not the case, the…

Scope IEC 60601-1:2005+AMD1:2012, 1.1 is replaced by: This document is applicable to the basic safety and essential performance of oxygen conserving equipment, hereafter referred to as ME equipment, in combination with its accessories intended to conserve supplemental oxygen by delivering gas intermittently and synchronized with the patient's inspiratory cycle, when used in the home…

Scope IEC 60601-1:2005+AMD1:2012, 1.1 is replaced by: This document specifies requirements for the basic safety and essential performance of an oxygen concentrator in combination with its accessories, hereafter referred to as ME equipment, intended to increase the oxygen concentration of gas intended to be delivered to a single patient. Such oxygen concentrators are typically intended for use…