Rechercher

Is divided into three sections, each dealing with specific examples of standardized dimensions. Section I: Fuse-links having bolted connections: Type A, Type B, Type C. Section II: Fuse-links with flush end connections: Type A, Type B. Section III: Fuse-links with cylindrical contact caps: Type A. This standard covers dimensional systems but does not standardize characteristics.

This National Standard of Canada is equivalent to International Standard CEI/IEC 60079-5:1997. 1 Scope This part of IEC 60079 contains the specific requirements for the construction, testing and marking of electrical apparatus, parts of electrical apparatus and Ex components in the type of protection powder filling "q", intended for use in potentially explosive atmospheres of gas,…

Scope This Code covers all electrical work and electrical equipment operating or intended to operate at all voltages in electrical installations for buildings, structures, and premises, including factory-built relocatable and non-relocatable structures, and self-propelled marine vessels stationary for periods exceeding five months and connected to a shore supply of electricity…

Scope This Code covers all electrical work and electrical equipment operating or intended to operate at all voltages in electrical installations for buildings, structures, and premises, including factory-built relocatable and non-relocatable structures, and self-propelled marine vessels stationary for periods exceeding five months and connected to a shore supply of electricity continuously or…

This part of ISO/IEC 14776 defines a protocol for the transport of commands and data over High Performance Serial Bus. The transport protocol, Serial Bus Protocol 2 or SBP-2, requires implementations to conform to the requirements of this standard as well as to ISO/IEC 13213:1994 and permits the exchange of commands, data and status between initiators and targets connected to Serial Bus.

This International Standard specifies dimensions and performance requirements for ports and stud ends with parallel threads for pneumatic fluid power applications. It specifies reusable, positively retained seals for leak-free connections, for use at pressures from ? 0,09 MPa (? 0,9 bar 1)) up to 1,6 MPa (16 bar). Only this International Standard is applicable for threaded ports and stud ends…

In addition to the general requirements of IEC 60077-2, it gives the rules for circuit-breakers, the main contacts of which are to be connected to d.c. power and/or auxiliary circuits. The nominal voltage of these circuits does not exceed 3 000 V d.c. according to IEC 60850.

Donne en complément des règles générales de la CEI 60077-2, les règles relatives aux disjoncteurs dont les contacts sont destinés à être connectés aux circuits à courant continu de traction et/ou aux circuits des auxiliaires. La tension continue nominale de ces circuits nexcède pas 3 000 V conformément à la CEI 60850.

Describes measurement procedures for quantifying the power quality of a grid connected wind turbine and the procedures for assessing compliance with power quality requirements.