Safety and control devices for gas burners and gas-burning appliances — Particular requirements — Pa...
This document specifies safety, construction, performance and testing requirements of multifunctional controls (MFC) intended for use with gas burners, gas appliances and appliances of similar use.
This document applies to an MFC with declared maximum inlet pressures up to and including 50 kPa (500 mbar) of nominal connection sizes up to and including DN 150 for use on burners or in appliances…
IEC 63267-1: 2023 covers enhanced macrobend loss 50 µm core diameter multimode fibre optic connection interfaces. It includes references, document structure details, definitions, and standardised optical connection grades. The grades are based on random mated connections between two optical connector populations according to prescribed characteristics including the core diameter and numerical…
This document defines the requirements for the external test equipment as:
— a means of establishing communications between a WWH-OBD-equipped vehicle and external test equipment;
— a set of diagnostic services, including addressing methods, to be provided by the external test equipment in order to exercise the services defined in ISO 27145‑3.
This document describes the minimum…
Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehic...
IEC PAS 63472:2023 describes dimensional options for CONFIGURATION FF AC/DC contact-tube vehicle couplers as defined in IEC 62196-3. These possibilities serve to improve the reliability of a mated connection when the charging cable is not axially constrained. The options can be implemented optionally and maintain mating compatibility with CONFIGURATION FF according to IEC 62196-3.
Photovoltaic power systems - DC arc detection and interruption
IEC 63027:2023 applies to equipment used for the detection and optionally the interruption of electric DC arcs in photovoltaic (PV) system circuits. The document covers test procedures for the detection of series arcs within PV circuits, and the response times of equipment employed to interrupt the arcs.
The document defines reference scenarios according to which the testing is conducted. This…
1 Scope
1.1 Inclusions
This Standard sets forth a set of minimum performance requirements for portable engine fuelling systems (PEFS) with a rated capacity of not more than 32 L (8.45 US gal), designed to be connected to gasoline-fueled engines aboard boats by flexible fuel lines that can be disconnected for refilling and portability. It applies to PEFS intended to be used with gasoline…
Mechanically laminated timber — Production and qualification specifications
1 Scope
1.1 Overview
This Standard provides minimum requirements for the manufacture of MLT using laminations of graded lumber connected parallel to each other along the wide face with metal or wooden fasteners.
1.2 Inclusions
Two qualification paths are provided for prescriptive and custom MLT, respectively, in this Standard:
a)
For prescriptive MLT, the design specifications (in the form…
STANDARD FOR VISIBLE SIGNALING DEVICES FOR FIRE ALARM AND SIGNALING SYSTEMS, INCLUDING ACCESSORIES
Scope
1.1 This Standard applies to visual signaling devices intended for indoor and/or outdoor installation:
a) In Canada only: in accordance with CSA C22.1, Canadian Electrical Code, Part I, Safety
Standard for Electrical Installations; and with ULC-S524, Standard for Installation of Fire Alarm
Systems.
b) In the United States only: in accordance with the National Electrical Code, NFPA 70,…
UAS traffic management (UTM) — Part 8: Remote identification
This document defines the generic concept and common framework of unmanned aircraft system (UAS) remote identification, which is mainly used to electronically identify an in-flight unmanned aircraft (UA). This document sets the minimum performance standards for direct remote identification.
This document does not cover requirements for modules installed in UA or requirements for network remote…
Welding — Quality requirements for heat treatment in connection with welding and allied processes
This document provides quality requirements for heat treatment in air or controlled atmospheres carried out in workshops and on site in connection with welding and forming. It applies mainly to ferritic steels but can be used for other materials as appropriate.
This document provides guidance for manufacturers that perform heat treatment or produce heat-treated products or components. This…