Rechercher

IEC TS 62257-5:2015(E) specifies the general requirements for the protection of persons and equipment against electrical hazards to be applied in decentralised rural electrification systems. Requirements dealing with protection against electric shock are based on basic rules from IEC 61140 and IEC 60364. Decentralized Rural Electrification Systems are designed to supply electric power for sites…

IEC 62153-4-7:2015 describes a triaxial method, suitable to determine the surface transfer impedance and/or screening attenuation and coupling attenuation of mated screened connectors (including the connection between cable and connector) and cable assemblies. This method could also be extended to determine the transfer impedance, coupling or screening attenuation of balanced or multipin…

IEC 62153-4-7:2015 describes a triaxial method, suitable to determine the surface transfer impedance and/or screening attenuation and coupling attenuation of mated screened connectors (including the connection between cable and connector) and cable assemblies. This method could also be extended to determine the transfer impedance, coupling or screening attenuation of balanced or multipin…

ISO 18563-3:2015 concerne l'appareillage d'essais par ultrasons équipé de traducteurs linéaires multiéléments, en contact (avec ou sans sabot) ou en immersion, avec des fréquences centrales comprises entre 0,5 MHz et 10 MHz. Elle décrit les méthodes et les critères d'acceptation applicables à la vérification des performances de l'équipement complet (à savoir appareil,…

ISO 18563-3:2015 addresses ultrasonic test systems implementing linear phased array probes, in contact (with or without wedge) or in immersion, with centre frequencies in the range of 0,5 MHz?10 MHz. It provides methods and acceptance criteria for verifying the performance of combined equipment (i.e. instrument, probe and cables connected). The methods described are suitable for users working…

ISO 18246 :2015 spécifie les exigences de sécurité relatives au couplage conductif des cyclomoteurs et motocycles à propulsion électrique à une borne d'alimentation électrique externe. ISO 18246 :2015 ne s'applique pas aux véhicules qui ne sont pas dans des conditions normales, tels que des véhicules endommagés et des véhicules présentant une défaillance mécanique et/ou électrique. ISO…

ISO 18246:2015 specifies safety requirements for conductive connection to an external electric power supply of electrically propelled mopeds and motorcycles. It is not applicable to vehicles not in normal conditions, such as damaged vehicles and vehicles which have mechanical and/or electrical failure. It applies only to on-board charging systems between the plug or vehicle couplers and RESS…

1.1 This Standard applies to electric clothes dryers intended to be used in nonhazardous locations in accordance with the Canadian Electrical Code, Part I (CE Code, Part I) and the (U.S.) National Electrical Code (NEC), on circuits having a nominal voltage not exceeding 600 V. Note: Wherever practical, for convenience, the term ²appliance² has been used in lieu of ²clothes dryer² or ²machine²…

1.1 This Standard applies to submersible lighting systems and associated components for installation in accordance with the Canadian Electrical Code, Part I that are: a) permanently connected to branch circuit; or b) portable type, cord-connected or direct plug-in type 1.2 This Standard covers submersible lighting systems for connection to a supply circuit of not more than 150 V, intended…

1.1 This Standard applies to a) indoor and outdoor use Class 2 power supplies with input power of 660 W or less. These units are of both the direct plug-in and cord-connected types that utilize a step-down, isolating transformer and that may incorporate rectifiers and other components to provide an ac or dc output; b) Class 2 power supplies as in Item a) employed as battery chargers for…