STANDARD FOR COMPOUNDS AND TAPES FOR THREADED PIPE JOINTS
Scope:
This Standard sets forth minimum requirements for the determination of the acceptability of pipe joint compounds and tapes for piping systems intended for the containment of alcohol, alcohol fuel blends, natural gas and methane, oxygen, petroleum distillates, propane and butane, steam, and water (potable and non-potable).
Unless otherwise specified, products meeting this Standard are…
Information technology — Biometrics used with mobile devices
ISO/IEC TR 30125:2016 provides guidance for developing a consistent and secure method of biometric (either alone or supported by non-biometric) personalization and authentication in a mobile environment for systems procured on the open market.
Guidance is provided for
- 1:1 verification or 1:few positive identification;
- biometric sample capture in the mobile environment where…
Information technology - Biometrics used with mobile devices
ISO/IEC TR 30125:2016 provides guidance for developing a consistent and secure method of biometric (either alone or supported by non-biometric) personalization and authentication in a mobile environment for systems procured on the open market.
Guidance is provided for
- 1:1 verification or 1:few positive identification;
- biometric sample capture in the mobile environment where…
Electrically propelled road vehicles — Specification of voltage sub-classes for voltage class B
ISO/PAS 19295:2016 provides specification of voltage sub-classes for electric propulsion systems and conductively connected auxiliary electric systems of electrically propelled road vehicles.
The voltage sub-classes are related to d.c. electric circuits.
It applies only to electric circuits and components with maximum working voltages according to voltage class B.
ISO/PAS 19295:2016 provides…
Fixed capacitors for use in electronic equipment - Part 14-2: Blank detail specification - Fixed cap...
IEC 60384-14-2:2016 forms the basis for a uniform procedure for a common International Safety Mark. It implements the approval schedule for safety tests in IEC 60384-14:2013, 1.4.2, requires a declaration of design for parameters relevant to safety and indicates conformance tests to be conducted on every lot prior to its release and requalification tests depending on changes to the declared…
Road vehicles — Communication between vehicle and external equipment for emissions-related diagnosti...
ISO 15031-3:2016 references the latest publication of SAE J1962.
On-board diagnostic (OBD) regulations require road vehicles to be equipped with a standardized connector for purposes of access to OBD information by ISO 15031‑4 compliant external test equipment. This part of ISO 15031 describes the requirements for the physical connection and associated pin usage to allow for standard access to…
1.1 General
This Standard details mechanical, physical, and electrical requirements for a newly manufactured
appliance that dispenses natural gas for vehicles directly into the vehicle natural gas fuel storage
system, referred to as a residential fueling appliance (RFA).
1.2 Application
These requirements apply to appliances:
a) for natural gas only (see Clause 1.1);
b) for outdoor or…
1.1
This Standard applies to modular wiring systems combined with the office furniture in which they are intended to be used.
1.2
This Standard applies to equipment intended to be permanently connected to one or more supply circuits at a nominal system voltage of 120 V to ground, and a rating of 15 or 20 A maximum per circuit, for use in nonhazardous locations, in accordance with the Rules of…
Fuel gas piping systems using corrugated stainless steel tubing
1.1
This Standard applies to fuel gas piping systems using corrugated stainless steel tubing (CSST), intended
for installation in residential, commercial or industrial buildings, and including the following
components as a minimum:
a) Corrugated stainless steel tubing (CSST);
b) Fittings for connection to the CSST; and
c) Striker plates (see Clause 3, Definitions) to protect the installed…
