Rechercher

IEC TS 61400-25-71:2019 focus on the communications between wind power plant components such as wind turbines and actors such as SCADA systems. Non­-IEC 61850/IEC 61400-25 internal communication within wind power plant components is outside the normative scope of the IEC 61400-25 series. This document describes how to extend the IEC 61400-25 series with the IEC 61850­6 Substation Configuration…

1 Scope 1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, Part I, CSA C22.1. 1.2 These ferrules are intended to facilitate the connection of stranded wire on to devices, such as terminal blocks. Their purpose is to treat stripped wire and…

1 Scope 1.1 General This Standard provides criteria in accordance with the National Building Code of Canada, for the structural design and evaluation of structures or structural elements made from wood or wood products, including: a) graded lumber; b) glued-laminated timber; c) cross-laminated timber (CLT); d) unsanded plywood; e) oriented strand board (OSB); f) composite building…

IEC 60068-3-3:2019 RLV contains both the official IEC International Standard and its Redline version. The Redline version is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition. IEC 60068-3-3:2019 applies primarily to electro-technical equipment but its application can be extended to other…

IEC 62751-2:2014+A1:2019 gives the detailed method to be adopted for calculating the power losses in the valves for an HVDC system based on the "modular multi-level converter", where each valve in the converter consists of a number of self-contained, two-terminal controllable voltage sources connected in series. It is applicable both for the cases where each modular cell uses only a…

IEC 60068-3-3:2019 applies primarily to electro-technical equipment but its application can be extended to other equipment and to components. In addition, if some type of analysis is always performed when making a seismic qualification, for example for the choice of the representative sample to be tested or for the extension of the seismic qualification from the tested specimen to similar…

IEC 63137-1:2019 defines general requirements for standard test radio frequency (RF) connectors (grade 0), including terms and definitions, ratings and characteristics, general requirements, test methods, quality assessment procedures, and etc. Standard test radio frequency (RF) connectors (grade 0) are intended to measure grade 1 and grade 2 RF connectors for electrical performances. Typically…

This document provides an overview for selecting the most suitable test method regarding the evaluation of the hardness and the wear resistance of coatings. Annex A gives a summarized list of test methods for the evaluation of the hardness and of the wear resistance of coatings for different stresses. Methods for testing cross-linking (wear test in connection with solvents) and abrasion tests…

This document defines the general minimum specifications of a type 2 two-way connection interface, linking the pyrotechnic device and harness connector built into a road vehicle.

This document covers the design, manufacture, performance, operation, functioning and testing of incinerators intended to incinerate garbage and other shipboard wastes generated during a ship's normal service (i.e. maintenance, operational, domestic and cargo-associated wastes). This document is applicable to incinerator plants with capabilities up to 4 000 kW per unit. This document is not…