Rechercher

The purpose of IEC 63132-1:2020 is to establish, in a general way, suitable procedures and tolerances for the installation of hydroelectric turbines and generators. This document presents a typical assembly. There are many possible ways to assemble a unit. The size of the machines, design of the machines, layout of the powerhouse and delivery schedule of the components are some of the elements…

The purpose of IEC 63132-2:2020 is to establish, in a general way, suitable procedures and tolerances for installation of generator. This document presents a typical assembly. There are many possible ways to assemble a unit. The size of the machines, design of the machines, layout of the powerhouse or delivery schedule of the components are some of the elements that could result in additional…

This document applies to hearing aid fitting management (HAFM) services offered by hearing aid professionals (HAP) when providing benefit for their clients. The provision of hearing aids relies on the knowledge and practices of a hearing aid professional, to ensure the proper fitting and adequate service in the interest of the client with hearing loss. This document specifies general processes of…

This document specifies quality aspects that can be defined but that are not normally found on a drawing specification. It covers the following: — single‑piece piston rings of grey cast iron or steel; — multi‑piece piston rings (oil control rings) consisting of cast iron parts and spring components; and — single‑piece and multi‑piece oil control rings of steel, i.e. oil control rings…

This document specifies general information regarding the manual shut off valve component of liquefied petroleum gas fuel, intended for use on the types of motor vehicles as defined in ISO 3833. It provides general design principles and specifies requirements for instructions and marking. It also specifies test requirements for the manual shut off valve. This document is applicable to vehicles (…

This document aims at providing general utilization requirements and recommendations and calculation methods adequate to guarantee the effectiveness and ultimate load strength of tie-down/lashing arrangements performed to restrain cargo on board civil transport aircraft during flight: a) cargo loaded and tied down onto airworthiness approved air cargo pallets, themselves restrained into…

1 Scope This document provides requirements and guidance for the structural design and/or assessment of floating offshore platforms used by the petroleum and natural gas industries to support the following functions: — production; — storage and/or offloading; — drilling and production; — production, storage and offloading; — drilling, production, storage and offloading. NOTE 1 Floating…

This document specifies general information regarding the non-return valve component of liquefied petroleum gas fuel, intended for use on the types of motor vehicles as defined in ISO 3833. It provides general design principles and specifies requirements for instructions and marking. It also specifies test requirements for the non-return valve. This document is applicable to vehicles (mono-fuel,…

This document specifies general information regarding the gas-tight housing component of liquefied petroleum gas fuel, intended for use on the types of motor vehicles defined in ISO 3833. It provides general design principles and specifies requirements for instructions and marking. It also specifies test requirements for the gas-tight housing. This document is applicable to vehicles (mono-fuel,…

This document specifies a set of key indicators for assessing the quality of museums: — for the purpose of strategic planning and internal management of museums; — for reporting to stakeholders such as funding institutions, policy makers, or the public; — to promote the museums' role and value for learning and research, education and culture, social and economic life; — for…