Rechercher

The standards-making procedures of ISO and IEC and their members are at the disposal of intergovernmental organizations and national governmental agencies wishing to use the principle of reference to standards. This Guide gives 5 principles which have been adopted by the ISO and IEC Councils with a view to guiding the work of ISO and IEC towards standards which can be referenced in legislation or…

The dimensions of weft pirns for automatic looms are specified. The dimensions shall be as shown in the tables (table 1: Dimensions - dimensions in national standards may lie anywhere within the indicated range -; table 2: Length and diameters). Dimensions of the pirn tip shall be as given in ISO 1131.

This Guide establishes certain basic principles for the functioning of a system of product information. It concerns those cases where the information is based in general on standards approved or recognized by ISO, IEC or the national standards body, and is one of a series dealing with various aspects of consumer information, including comparative testing and marks of conformity with standards.

Specifies the main dimensions for the certain number of tool types, and the codified designation of dies and the marking. Details not indicated are left to the discretion of the manufacturers or should be specified in national standards. Includes, in annex A, a comparison of several dimensions for various types of drawing dies, and, in annex B, a terminology, in several languages, for…

Contains specification sheets for three groups of plugs and socket-outlets for domestic and similar general use: Group A:American National Standards Institute (ANSI) Group B:British Standards Institution (BSI) Group C:International Commission on Rules for the Approval of Electrical Equipment (CEE) This publication has the status of a technical report.

1.1 These requirements cover indicating pressure gauges of the elastic element type for use with sprinkler or standpipe equipment for fire protection service. The nominal sizes of gauges covered by these requirements are limited to 3-1/2 and 4-1/2 inches. 1.2 Requirements for the installation and use of the gauges covered by this Guide are included in the Standards of the National Fire…

1.1 These requirements cover hydrants employed in piping systems supplying water for fire-protection service. 1.2 Requirements for the installation and use of hydrants covered by these requirements include, among others, the Standard of the National Fire Protection Association for Outside Protection, NFPA 24.

Specifies the factors which need to be taken into consideration in the selection of methods for the exposure to natural weathering of paint films or systems for the purpose of evaluating their durability. A method is specified which is recommended for the use where no specialized requirements apply. Supplementary information shall be derived from the national standard or shall be the subject of…

Specifies the tests suitable for establishing the compliance of cables with the performance requirements stated in ISO 2155. Is intended to serve as a basis for test specifications to be included in the relevant national standards when the Official Board of Inspection considers that existing tests are inadequate. The tests are classified in type tests only, type tests and routine productions…

This International Standard specifies the rest procedures suitable for establishing the compliance of wires with the performance requirements stated in ISO 2032. They are intended for use as a basis for specifying tests in the relevant national specifications when the national type approving authorities consider that existing tests are inadequate. The test procedures are classified in type tests…