Rechercher

This National Standard of Canada is equivalent to International Standard ISo 789/6-1982. This part of ISO 789 specifies a method of determining the position of the centre of gravity of agricultural tractors. The method is applicable to agricultural tractors having at least two axles fitted with wheels or tracks.

This National Standard of Canada is equivalent to International Standard ISO 789/2-1983. It specifies test procedures for determining the following hydraulic performance characteristics of agricultural tractors: a) the maximum vertical force which can be exerted by the hydraulic lift at the lower hitch points throughout their full range of movement; b) the maximum vertical force…

This National Standard of Canada is equivalent to International Standard ISo 789/1-1981. It specifies test procedures for determining the power avail[Cable at the power take-off, drawbar and belt pulley on agricultural tractors of the wheeled, track-laying or semi-tracklaying type. It is permissible for the p.t.o. power test or the drawbar test to be applied alone or in combination.…

1. Scope 1.1 This Standard provides a calculation method for determining the output capacity of a residential space heating appliance or group of appliances, and the output capacity of a residential cooling appliance or group of appliances required to maintain specified indoor environmental conditions under specified outdoor environmental conditions. 1.2 This Standard also provides restrictions…

This National Standard of Canada is based on International Standard IEC 601-1:1988. NOTE - Amendment 2:1998 to this document was reaffirmed November 10, 2006. It applies to the safety of MEDICAL ELECTRICAL EQUIPMENT (as defined in Sub-Clause 2.2.15) designed to be installed and used in accordance with the rules of the Canadian Electrical Code, Part I. Although this Standard is primarily…

This National Standard of Canada is based on International Standard IEC 601-2-4:1983. 1 Scope This Particular Standard specifies requirements for the safety of CARDIAC DEFIBRILLATORS and CARDIAC DEFIBRILLATOR-MONITORS as defined in Sub-clauses 2.1.101 and 2.1.102, hereinafter referred to as EQUIPMENT, incorporating a capacitive energy storage device and which are designed to be installed…

This National Standard of Canada is equivalent to International Standard ISO 5353-1978. It specifies a method and a device for use in establishing the position of the seat index point (SIP) for any kind of padded seat.

This National Standard of Canada is equivalent to International Standard ISO 1989-1985. Preface This is the first edition of CSA Standard CAN/CSA-Z243.39, Programming Language - COBOL, and is an adoption of ISO Standard 1989-1985, which, in turn, is an adoption of ANSI Standard X3.23-1985, American National Standard for Information Systems - Pr ogramming Language - COBOL. This Standard…

Gives the requirements relating to the sizes and material of tubing for use in hydraulic pressure and return systems. For pressure lines, the requirements apply to the pressure and temperature ranges covered by pressure classes D and E and temperature types II and III as specified in ISO 6771. Tubing materials are included in table 1, outside diameters, wall thicknesses and materials for…

This National Standard of Canada is equivalent to International Standard ISO/IEC 8881-1989. 1 Scope This International Standard deals with the use of the X.25 Packet Level Protocol (PLP) as specified in ISO 8208 operating over ISO 8802 Local Area Networks (LANs). Section 2 of this International Standard specifies the operation of the X.25/PLP using the Logical Link Control (LLC) Type 2…