Rechercher

This National Standard of Canada is equivalent to International Standard ISO 19904-1:2006. 1 Scope This part of ISO 19904 provides requirements and guidance for the structural design and/or assessment of floating offshore platforms used by the petroleum and natural gas industries to support the following functions: - production; - storage and/or offloading; - drilling and production; -…

This National Standard of Canada is joint with UL 60745-2-5; and both are based on International Standard IEC 60745-2-5. 1 Scope This clause of Part 1 is applicable, except as follows: Addition: This standard applies to all types of circular saws. Circular saws hereinafter will be referred to as saws. This standard does not apply to saws used with abrasive wheels.

This National Standard of Canada is joint with UL 60745-1; and both are based on International Standard IEC 60745-1. 1 Scope This part of IEC 60745 deals with the safety of hand-held motor-operated or magnetically driven electric tools, the rated voltage of the tools being not more than 250 V for single-phase a.c. or d.c. tools, and 440 V for three-phase a.c. tools. So far as is…

ISO 7240-16:2007 specifies the requirements, test methods and performance criteria for sound system control and indicating equipment (s.s.c.i.e.) for use in buildings and structures as part of a sound system for emergency purposes (s.s.e.p.) aas defined in ISO 7240-1. The s.s.c.i.e. is primarily intended to broadcast information for the protection of lives within one or more specified areas in an…

ISO 15614-7:2007 specifies how a preliminary welding procedure specification for overlay welding is qualified by welding procedure tests. ISO 15614-7:2007 defines the conditions for carrying out welding procedure tests and the range of qualification for welding procedures for all practical welding operations within the range of variables listed in Clause 8. Additional tests may be required by…

The purpose of this technical specification is to establish standard methods for a qualitative check of the performance of ultrasound physiotherapy devices during their lifetime, and to provide guidance on calibration requirements and techniques. To ensure that the ultrasound physiotherapy equipment is in an appropriate condition for use, a regular quality check is necessary. This technical…

This National Standard of Canada is equivalent to International Standard ISO 14971:2007. 1 Scope This International Standard specifies a process for a manufacturer to identify the hazards associated with medical devices, including in vitro diagnostic (IVD) medical devices, to estimate and evaluate the associated risks, to control these risks, and to monitor the effectiveness of the controls…

ISO/TS 10465-1:2007 describes the procedures for underground installation of flexible glass-reinforced thermosetting resin (GRP) pipes. It refers generally to GRP pipes as specified in the system standards ISO 10467 and ISO 10639, but it can also be used as a guide for the installation of other GRP pipes. It does not include jacking, relining or above-ground installations; nor does it cover…

This National Standard of Canada is equivalent to International Standard ISO 500-1:2004. 1 Scope This part of ISO 500 gives general specifications, including speeds, safety requirements, the dimensions for the master shield and clearance zones for rear-mounted power take-offs (PTOs) of types 1, 2 and 3 on agricultural tractors with a track setting of more than 1 150 mm (those with a track…

This National Standard of Canada is equivalent to International Standard ISO 500-2:2004. 1 Scope This part of ISO 500 specifies the dimensions of the master shield and clearance zones for rear-mounted power take-offs (PTO) of types 1 and 2 on narrow-track (track width 1 150 mm or less) agricultural tractors. *********************************** ISO 500-2:2004 endorsed standard replaces this…