Rechercher

IEC 62317-1:2007 specifies the standards and existing projects dealing with dimensions of ferrite cores. It is intended that this standard will include ferrite cores which are widely used and referenced in industry, either because they are included in national standards, or because they are seen to have broad-based use in industry. Where applicable, it is intended that the existing industrial…

ISO/TR 27809:2007 considers the control measures required to ensure patient safety in respect to health software products. It does not apply to software which is: necessary for the proper application of a medical device or an accessory to a medical device or a medical device in its own right. ISO/TR 27809:2007 is aimed at identifying what standards might best be used or created, and their…

IEC 60601-1-9:2007 The objective of this collateral standard is to improve the environmental impact for the entire range of medical electrical equipment, taking into account all stages of the product life cycle: - product specification; - design; - manufacturing; - sales, logistics, installation; - use; - end of life management. This means protecting the environment and human health from…

ISO 18416:2007 gives general guidelines for the detection and identification of the specified microorganism Candida albicans in cosmetic products. Microorganisms considered as specified in this International Standard might differ from country to country according to national practices or regulations. The method described in ISO 18416:2007 is based on the detection of Candida albicans in a non-…

This National Standard of Canada is equivalent to International Standard ISO 19904-1:2006. 1 Scope This part of ISO 19904 provides requirements and guidance for the structural design and/or assessment of floating offshore platforms used by the petroleum and natural gas industries to support the following functions: - production; - storage and/or offloading; - drilling and production; -…

This National Standard of Canada is joint with UL 60745-2-5; and both are based on International Standard IEC 60745-2-5. 1 Scope This clause of Part 1 is applicable, except as follows: Addition: This standard applies to all types of circular saws. Circular saws hereinafter will be referred to as saws. This standard does not apply to saws used with abrasive wheels.

This National Standard of Canada is joint with UL 60745-1; and both are based on International Standard IEC 60745-1. 1 Scope This part of IEC 60745 deals with the safety of hand-held motor-operated or magnetically driven electric tools, the rated voltage of the tools being not more than 250 V for single-phase a.c. or d.c. tools, and 440 V for three-phase a.c. tools. So far as is…

ISO 7240-16:2007 specifies the requirements, test methods and performance criteria for sound system control and indicating equipment (s.s.c.i.e.) for use in buildings and structures as part of a sound system for emergency purposes (s.s.e.p.) aas defined in ISO 7240-1. The s.s.c.i.e. is primarily intended to broadcast information for the protection of lives within one or more specified areas in an…

ISO 15614-7:2007 specifies how a preliminary welding procedure specification for overlay welding is qualified by welding procedure tests. ISO 15614-7:2007 defines the conditions for carrying out welding procedure tests and the range of qualification for welding procedures for all practical welding operations within the range of variables listed in Clause 8. Additional tests may be required by…

The purpose of this technical specification is to establish standard methods for a qualitative check of the performance of ultrasound physiotherapy devices during their lifetime, and to provide guidance on calibration requirements and techniques. To ensure that the ultrasound physiotherapy equipment is in an appropriate condition for use, a regular quality check is necessary. This technical…