Rechercher

"This National Standard of Canada is applicable to insulating foam-filled tubes and solid rods made of synthetic materials and intended for tools and equipment for live work on systems operating at voltages above 1 kV. Separate special technical standards give details of tests for fittings and attachments to these poles and rods, adaptable tools and…

This National Standard of Canada is based on International Standard IEC/TR 61000-3-6:2008. 1 Scope This Technical Report, which is informative in its nature, provides guidance on principles which can be used as the basis for determining the requirements for the connection of distorting installations to MV, HV and EHV public power systems (LV installations are covered in other IEC documents).…

"This National Standard of Canada applies to the terminology used to describe tools, equipment, devices and methods used in live working. This Standard permits identification of the tools, equipment and devices and standardizes their names."

This National Standard of Canada is applicable to portable equipment, with or without matching connection points, for temporary earthing or earthing and short-circuiting of electrically isolated or de-energized a.c. and d.c. installations, transmission and distribution networks, whether they are overhead or underground or of low or high voltage. This standard covers equipment comprising an…

"This National Standard of Canada is applicable to saddles and pole clamps (stick clamps) used for live working, and to their accessories. This Standard specifies the dimensional and mechanical characteristics to be given by the manufacturer for each tool, the corresponding mechanical tests, and the other points to be checked (visual, functional, marking, etc.)"

This National Standard of Canada is based on International Standard IEC 60335-2-79:2002. 1 Scope This clause of Part 1 is replaced by the following. This International Standard deals with the safety of high pressure cleaners for household, industrial and commercial use having a pressure not less than 2,5 MPa and not more than 25 MPa and with an input to the drive for the high pressure pump not…

This National Standard of Canada is based on International Standard IEC 60384-14:2005. Scope This part of IEC 60384 applies to capacitors and resistor-capacitor combinations which will be connected to an a.c. mains or other supply with nominal voltage not exceeding 1 000 V a.c. (r.m.s.) or 1 000 V d.c. and with a nominal frequency not exceeding 100 Hz.

This National Standard of Canada is based on International Standard ISO 11135-1:2007. Scope This part of ISO 11135 specifies requirements for the development, validation and routine control of an ethylene oxide sterilization process for medical devices. NOTE 1 Although the scope of this part of ISO 11135 is limited to medical devices, it specifies requirements and provides guidance that…

This National Standard of Canada is equivalent to International Standard ISO 15883-2:2006. 1 Scope This part of ISO 15883 specifies particular requirements for washer-disinfectors (WD) that are intended for use for the cleaning and thermal disinfection, in a single operating cycle, of re-usable medical devices such as surgical instruments, anaesthetic equipment, bowls, dishes and receivers,…

This National Standard of Canada is equivalent to International Standard ISO/TS 15883-5:2005. 1 Scope This Technical Specification includes the test soils and methods that can be used to demonstrate the cleaning efficacy of washer-disinfectors (WD) according to the ISO 15883 series of standards. The inclusion of the test soils and methods in this Technical Specification does not indicate…