Rechercher

IEC 62287-2:2013 specifies operational and performance requirements, methods of testing and required test results for Class B "SO" shipborne AIS equipment using Self-organised TDMA (SOTDMA) techniques as described in Recommendation ITU-R M.1371. This standard takes into account other associated IEC International Standards and existing national standards, as applicable. The main…

ISO 12345:2013 specifies cleanliness assessment procedures for evaluating the amount of debris found within the clean side of diesel fuel injection assemblies, which could lead to a reduction in the system's operational effectiveness. While other International Standards, e.g. the ISO 16232 series, relate to cleanliness of components used in road vehicle fluid circuits, ISO 12345:2013 is…

ISO 26683-1:2013 provides the context for application interface profiles for the exchange of land transport data using current technologies and existing standards for item identification, package identification, container identification, and international standards and practices regarding freight and its movement.

ISO 29462:2013 describes a procedure for measuring the performance of general ventilation air cleaning devices in their end use installed configuration. The performance measurements include removal efficiency by particle size and the resistance to airflow. The procedures for test include the definition and reporting of the system airflow. The procedure describes a method of counting ambient air…

The data protocol used to exchange information in a radio frequency identification (RFID) system for item management is specified in ISO/IEC 15961 and in ISO/IEC 15962:2013. Both International Standards are required for a complete understanding of the data protocol in its entirety; but each focuses on one particular interface: ISO/IEC 15961 addresses the interface with the application system.…

The data protocol used to exchange information in a radio frequency identification (RFID) system for item management is specified in ISO/IEC 15961 and in ISO/IEC 15962:2013. Both International Standards are required for a complete understanding of the data protocol in its entirety; but each focuses on one particular interface: ISO/IEC 15961 addresses the interface with the application system.…

ISO 16911-1:2013 specifies a method for periodic determination of the axial velocity and volume flow rate of gas within emissions ducts and stacks. It is applicable for use in circular or rectangular ducts with measurement locations meeting the requirements of EN 15259. Minimum and maximum duct sizes are driven by practical considerations of the measurement devices described within ISO 16911-1:…

ISO 6887-6:2013 specifies rules for the preparation of samples taken at all stages from the farm to the slaughterhouse and their suspension for microbiological examination when the samples require different preparation from the methods described in ISO 6887-1. ISO 6887-6:2013 excludes the preparation of samples for both enumeration and detection test methods where preparation details are…

1 Scope This Recommendation | International Standard specifies a protocol which is used by application layer entities to exchange management information. This Recommendation | International Standard specifies: – procedures for the transmission of management information between application entities; – the abstract syntax of the Common Management Information Protocol (CMIP) and the associated…

Scope 1.1 This standard applies to excess flow valves constructed entirely of new unused parts and materials intended for use after the service meter or second stage regulator (see Clause 3), hereinafter referred to as valves, not to exceed 2 in (50.8 mm) nominal pipe size. 1.2 Valves covered by this standard shall automatically limit the downstream flow of gas in the event that the flow reaches…