Rechercher

ISO/IEC 26555:2015 deals with the tools and methods of technical management for software products, software services, software-intensive systems (including System Architecture and excluding hardware) within a product line. The scope of this International Standard is as follows: ? Enable the users of this standard to holistically understand, adopt, and enact the processes, tools, and methods for…

ISO 11623:2015 specifies the requirements for periodic inspection and testing and to verify the integrity for further service of hoop-wrapped and fully-wrapped composite transportable gas cylinders, with aluminium-alloy, steel or non-metallic liners or of linerless construction (Types 2, 3, 4, and 5), intended for compressed, liquefied or dissolved gases under pressure, of water capacity from 0,5…

IEC 60601-1-12:2014 constitutes a collateral standard to IEC 60601-1: Medical electrical equipment - Part 1: General requirements for basic safety and essential performance hereafter referred to as the general standard. Medical practice is increasingly using medical electrical equipment and medical electrical systems for monitoring, treatment or diagnosis of patients in the emergency medical…

ISO 13141:2015 establishes requirements for short-range communication for the purposes of augmenting the localization in autonomous electronic fee collection (EFC) systems. Localization augmentation serves to inform on-board equipment (OBE) about geographical location and the identification of a charge object. This International Standard specifies the provision of location and heading information…

ISO 18185-3:2015 specifies test methods and conditions for environmental characteristics of electronic seals. ISO 18185-3:2015 describes the environmental requirements for the ISO 18185 series, for ISO 10374 and for ISO 17363 and for ISO 10891 since it is expected that the implementation of these International Standards will face the same international conditions. However, each of these…

ISO/IEC 29167-16:2015 describes a crypto suite based on Elliptic Curve Cryptography (ECC) for the ISO/IEC 18000‑ series of standards protocol. In particular, it specifies the use of Elliptic Curve Diffie-Hellman (ECDH) key agreement in a secure channel establishment and the use of Elliptic Curve Digital Signature Algorithm (ECDSA) in an authentication mechanism. ISO/IEC 29167-16:2015 specifies a…

ISO 636:2015 specifies requirements for classification of rods and wires in the as-welded condition and in the post-weld heat-treated condition for tungsten inert gas welding of non-alloy and fine-grain steels with a minimum yield strength of up to 500 MPa or a minimum tensile strength of up to 570 MPa. This International Standard is a combined specification providing classification utilizing a…

ISO 22717:2015 gives general guidelines for the detection and identification of the specified microorganism Pseudomonas aeruginosa in cosmetic products. Microorganisms considered as specified in this International Standard might differ from country to country according to national practices or regulations. In order to ensure product quality and safety for consumers, it is advisable to perform an…

ISO 21009-2:2015 specifies operational requirements for static vacuum insulated vessels designed for a maximum allowable pressure of more than 50 kPa (0,5 bar). It may also be used as a guideline for vessels designed for a maximum allowable pressure of less than 50 kPa (0,5 bar). ISO 21009-2:2015 applies to vessels designed for cryogenic fluids specified in ISO 21009‑1. Static cryogenic vessels…

ISO/IEC 29167-16:2015 describes a crypto suite based on Elliptic Curve Cryptography (ECC) for the ISO/IEC 18000‑ series of standards protocol. In particular, it specifies the use of Elliptic Curve Diffie-Hellman (ECDH) key agreement in a secure channel establishment and the use of Elliptic Curve Digital Signature Algorithm (ECDSA) in an authentication mechanism. ISO/IEC 29167-16:2015 specifies a…