Information technology - Security techniques - Testing methods for the mitigation of non-invasive at...
ISO/IEC 17825:2016 specifies the non-invasive attack mitigation test metrics for determining conformance to the requirements specified in ISO/IEC 19790 for Security Levels 3 and 4. The test metrics are associated with the security functions specified in ISO/IEC 19790. Testing will be conducted at the defined boundary of the cryptographic module and I/O available at its defined boundary.
The test…
Textile test methodsTextiles — Determination of twist in yarns — Direct counting method (ISO 2061:20...
1.1 This International Standard specifies a method for the determination of the direction of twist in yarns,
the amount of twist, in terms of turns per unit length, and the change in length on untwisting, by the direct
counting method.
1.2 This International Standard is applicable to
a) single yarns (spun and filament),
b) plied yarns, and
c) cabled yarns.
Separate procedures are given for…
1 Scope
1 Domaine d'application
This International Standard establishes a definition
for the term nonwovens.
La présente Norme internationale établit une
définition du terme nontissé.
Wind turbines - Part 13: Measurement of mechanical loads
IEC 61400-13:2015(B) describes the measurement of fundamental structural loads on wind turbines for the purpose of the load simulation model validation. The standard prescribes the requirements and recommendations for site selection, signal selection, data acquisition, calibration, data verification, measurement load cases, capture matrix, post-processing, uncertainty determination and reporting…
Safety of machinery — Fire prevention and fire protection
ISO 19353:2015 specifies methods for identifying fire hazards resulting from machinery and for performing a risk assessment.
It gives the basic concepts and methodology of protective measures for fire prevention and protection to be taken during the design and construction of machinery. The measures consider the intended use and reasonably foreseeable misuse of the machine.
It provides guidelines…
IEC 60846-2:2015 applies to portable or transportable dose equivalent (rate) meters and/or monitors for the measurement of ambient and/or directional dose equivalent (rate) from external beta, X and gamma radiation for energies up to 10 MeV during emergency situations. The object of this International Standard is to specify the design requirements and the performance characteristics of dose…
Specification for the testing of balanced and coaxial information technology cabling - Part 1: Insta...
IEC 61935-1:2015(E) specifies reference measurement procedures for cabling parameters and the requirements for field tester accuracy to measure cabling parameters identified in ISO/IEC 11801. References in this standard to ISO/IEC 11801 mean ISO/IEC 11801 or equivalent cabling standards. This International Standard applies when the cable assemblies are constructed of cables complying with the IEC…
Additive manufacturing — General principles — Terminology
ISO/ASTM 52900:2015 establishes and defines terms used in additive manufacturing (AM) technology, which applies the additive shaping principle and thereby builds physical 3D geometries by successive addition of material.
The terms have been classified into specific fields of application.
New terms emerging from the future work within ISO/TC 261 and ASTM F42 will be included in upcoming amendments…
Electronic fee collection — Information exchange between service provision and toll charging
ISO 12855:2015 specifies
- the interfaces between electronic fee collection (EFC) systems for vehicle related transport services, e.g. road user charging, parking and access control; it does not cover interfaces for EFC systems for public transport; an EFC system can include any EFC system, e.g. including systems that automatically read licence plate numbers of vehicles passing a toll point…
