Rechercher

Specifies the material for and dimensions of equipment for drilling in solid or weakly fissured medium hard or hard formations to depths of 1200 m to 1500 m. Applies to equipment with outer bit diameters of 46 mm, 59 mm, 76 mm and 93 mm with corresponding core diameters from 24 mm to 59 mm.

Spécifie les conditions minimales pour l'enregistrement des signaux sur l'amorce et en fin des bandes vidéo, afin de permettre à l'utilisateur un réglage optimal de l'appareil avant la diffusion du programme enregistré.

This National Standard of Canada is equivalent to American National Standards Institute (ANSI) standard T1.403-1989. This standard describes the metallic interface between a carrier and customer installation (CI), referred to as the network interface (NI), at the DS1 rate. It establishes requirements at the NI necessary for compatible operation between the carrier and the CI. Interfaces…

1.1 This Standard defines the alphanumeric lexical sequence for the English and French languages. It is intended for general-purpose sorting of all alphanumeric strings using the character repertoire of CSA Standard CAN/CSA-Z243.4 in Canada, wherever human intervention is involved or sorted results are presented to users. 1.2 Sorting is based on the rules of word ordering rather than on…

This National Standard of Canada is equivalent to American National Standards Institute standard ANSI T1.408-1990. 1.1 General It establishes performance and technical criteria for interfacing and interconnecting the various functional groups shown in figure 1. Compliance with this standard is intended to ensure compatibility at the interface points /a and /b (figure 1) and should not…

This National Standard of Canada is equivalent to International Standard ISO/IEC 8880-1:1990. 1 Scope This part of ISO/IEC 8880 specifies the protocol combinations to be used to support the OSI Network Service defined in ISO 8348 and its Addendum 1. The field of application of this part of ISO/IEC 8880 is that of the environments defined in the other parts of ISO/IEC 8880. The field…

Defines the axis systems. Describes the equipment, the position of dummy and moped, and the measuring procedure. Annex A (format to be used for measurement results) forms an integral part of this standard.

This National Standard of Canada is equivalent to International Standard ISO/IEC 8208:1990. This International Standard specifies the procedures, formats and facilities at the Packet Layer for Data Terminal Equipment (DTE) operating in conformance with CCITT Recommendation X.25. Both Virtual Call and Permanent Virtual Circuit modes of operation are covered. The Packet Layer protocol…

La présente Norme internationale fixe les spécifications relatives au format et à l'enregistrement normalisés de la bande magnétique à 9 pistes, de 12,7 mm (0,5 in) de large, utilisée pour l'échange d'information entre matériels de traitement de l'information, entre les systèmes de transmission et équipements associés utilisant le jeu de caractères codé à 7 éléments (voir ISO…

Provides a format and recording standard for 9-track, 12,7 (0,5 in) wide magnetic tape and reels to be used for information interchange among information processing systems, communication systems, and associated equipment utilizing the 7-bit coded character set specified in ISO 646 or its 7-bit or 8-bit extensions specified in ISO 2022. References: ISO 962; 1001; 1864.