Plastic piping systems — Mechanical joints between fittings and pressure pipes — Test method for lea...
ISO 3459:2015 specifies two methods of testing for checking the leaktightness of assembled joints between mechanical fittings and plastic pressure pipes up to and including 63 mm. The test applies regardless of the design and material of the fitting used for jointing plastics pipe.
This test method is not applicable to fusion-welded joints.
Plastics piping systems — Elastomeric-sealing-ring-type socket joints for use with plastic pressure ...
ISO 13844:2015 specifies a method for testing the leak tightness under negative pressure, angular deflection, and deformation of assembled joints between elastomeric-sealing-ring-type sockets made of plastic or metal and plastic pressure pipes.
Assembly tools for screws and nuts — Technical specifications — Part 2: Machine-operated sockets (im...
ISO 1711-2:2015 specifies hardness and minimum torsional strength for machine-operated square drive sockets in accordance with ISO 2725‑2 intended for use with impact wrenches.
Systèmes de canalisations en matières plastiques — Assemblages mécaniques entre raccords et tubes so...
L'ISO 3459:2015 spécifie deux méthodes d'essai pour la vérification de l'étanchéité des assemblages entre raccords mécaniques et tubes sous pression en plastique dont le diamètre est inférieur ou égal à 63 mm. Cette méthode est applicable quelles que soient la conception et la matière du raccord utilisé pour le raccordement des tubes en plastique.
La présente méthode d'essai n…
Outils de manoeuvre pour vis et écrous — Spécifications techniques — Partie 1: Clés de serrage et do...
ISO 1711-1:2015 spécifie les valeurs minimales de dureté Rockwell et de résistance à la torsion auxquelles doivent satisfaire les clés de serrage et les douilles à main.
Outils de manoeuvre pour vis et écrous — Spécifications techniques — Partie 2: Douilles à machine (i...
ISO 1711-2:2015 spécifie la dureté et la contrainte minimale de torsion pour les douilles à machine à carré d'entraînement conformes à ?ISO 2725‑2, prévues pour être utilisées avec des clés impact.
Aerospace series — Hydraulic filter elements — Test methods — Part 1: Test sequence
ISO 14085-1:2015 specifies a test sequence for evaluation of characteristics of the hydraulic fluid filter elements under standard conditions.
ISO 14085-1:2015 is not intended to qualify a filter element under replicate conditions of service; this can only be done by a specific test protocol developed for the purpose, including actual conditions of use, for example the operating fluid or…
Aerospace series — Hydraulic filter elements — Test methods — Part 2: Conditioning
ISO 14085-2:2015 specifies
- a procedure to thermally condition a hydraulic filter element to presumed aerospace hydraulic system stresses,
- a test procedure to complete cold soaks, hot soaks, and temperature variation in a combined manner, and
- a test procedure to simulate cold starts.
ISO 14085-2:2015 is not intended to qualify a filter element under replicate conditions of…
Aerospace series — Hydraulic filter elements — Test methods — Part 4: Verification of collapse/burst...
ISO 14085-4:2015 describes a method for verifying the collapse/burst pressure rating of an aerospace hydraulic fluid power filter element. This represents the capability of a filter element to withstand a designated differential pressure in the normal (intended) direction of flow, created by flowing contaminated fluid through the filter element until either collapse/burst occurs or the maximum…
