Rechercher

L'IEC 62842:2015 spécifie la méthode d'allocation d'espace exigé de fichier sans fragmentation, afin de réduire le plus possible la nécessité de réallocation de fichiers fragmentés dans le système de fichiers au format universel de disque (UDF - universal disk format) appliqué à des lecteurs de disque dur utilisés dans les enregistreurs à disque dur.

IEC 62680-1-1:2015 contains specifications that define limits as well as detection, control and reporting mechanisms to permit devices to draw current in excess of the USB 2.0 specification for charging and/or powering up from dedicated chargers, hosts, hubs and charging downstream ports. These mechanisms are backward compatible with USB 2.0 compliant hosts and peripherals.

L'IEC 62680-1-1:2015 contient des spécifications définissant des limites ainsi que des mécanismes de détection, de contrôle et de rapports pour permettre à des dispositifs de puiser une quantité de courant supérieure à celle prévue par la spécification USB 2.0 pour se charger et/ou s'allumer à l'aide de chargeurs, d'hôtes, de concentrateurs et de ports en aval de chargement…

ISO 17621:2015 specifies requirements and test methods under prescribed laboratory conditions for length-of-stain detector tubes and their associated pump (detector tube measurement system) used for short-term measurements of the concentration of specified chemical agents in workplace air. ISO 17621:2015 is not applicable to measurements made to demonstrate compliance with long-term limit values…

ISO 17621:2015 spécifie les exigences et les méthodes d'essai, dans des conditions de laboratoire prescrites, applicables aux tubes détecteurs à longueur de coloration et à leur pompe associée (système de mesurage par tube détecteur) utilisés pour les mesurages à court terme de la concentration d'agents chimiques spécifiés dans l'air des lieux de travail. ISO 17621:2015 ne s'…

IEC 60079-10-1:2015 is concerned with the classification of areas where flammable gas or vapour hazards may arise and may then be used as a basis to support the proper selection and installation of equipment for use in hazardous areas. It is intended to be applied where there may be an ignition hazard due to the presence of flammable gas or vapour, mixed with air, but it does not apply to:<br…

IEC 61726:2015 describes the measurement of screening attenuation by the reverberation chamber test method, sometimes named mode stirred chamber, suitable for virtually any type of microwave component and having no theoretical upper frequency limit. It is only limited toward low frequencies due to the size of the test equipment, which is frequency-dependent and is only one of several methods of…

ISO 11972:2015 specifies cast steels for general corrosion-resistant applications. The grades covered by this International Standard represent types of alloy steel castings suitable for broad ranges of application which are intended for a wide variety of corrosion applications. NOTE Annex A gives information on ISO grade designation and available UNS numbers which are similar to the ISO…

ISO 9838:2015 defines test soles representing - an alpine ski-boot (form A) or at least the bottom part of it to be used for testing alpine ski-bindings for alpine skiing in accordance with ISO 9462 and ISO 9465, and - a touring ski-boot (form T) or at least the bottom part of it to be used for testing touring ski-bindings for touring skiing in accordance with ISO 13992 and ISO 9465.…