Rechercher

This document specifies an empirical method for assessing the resistance of anodic oxidation coatings to cracking by deformation. The method is applicable particularly to sheet material with anodic oxidation coatings of thickness less than 5 µm, and is useful for development purposes. NOTE If the test specimen is thick, more than 5 µm of coating can be measured (see Clause 9).

This document specifies a test method for the determination of the resistance of fire dampers to heat, and for the evaluation of their ability to prevent fire and smoke spreading from one fire compartment to another through an air distribution system. It is applicable to mechanical fire dampers. It is not intended to be used for dampers used only in smoke control systems, for testing fire…

This document establishes minimum requirements for pressure relief devices intended for use on hydrogen fuelled vehicle fuel containers that comply with ISO 19881, IEC 62282-4-101, ANSI HGV 2, CSA B51 Part 2, EC79/EU406, SAE J2579, or the UN GTR No. 13. The scope of this document is limited to thermally activated pressure relief devices installed on fuel containers used with fuel cell grade…

This document specifies a screening test method for determining the resistance of geotextiles and geotextile-related products to oxidation. The test is applicable to products as follows: — Method A for material consisting solely in polypropylene (PP), polyethylene (PE), polyamide (PA), aramide (AR); — Method B for material consisting solely in polyvinyl alcohol (PVAL). The data…

Le présent document spécifie les exigences générales, l'étalonnage, les termes et définitions des caractéristiques des équipements de mesure GPS, par exemple micromètres, pieds à coulisse, cales étalons et instruments de mesure de forme à plateau tournant. Le présent document constitue la base des normes destinées à définir et à déterminer les caractéristiques de conception et les…

This document specifies the general requirements, calibration, terms and definitions of characteristics of GPS measuring equipment, for example micrometers, callipers, gauge blocks and rotary axis form measuring instruments. This document forms the basis for standards defining and describing the design characteristics and metrological characteristics for measuring equipment and gives guidance for…

Le présent document spécifie une méthode de détermination de la résistance à l'oxydation des géotextiles et des produits apparentés. L'essai est applicable aux produits décrits ci-dessous: — Méthode A, pour les matériaux exclusivement à base de polypropylène (PP), de polyéthylène (PE), de polyamide (PA), d'aramide (AR); — Méthode B, pour les matériaux…

This document specifies the safety requirements for self-propelled mobile machines used in underground mining, as defined in 3.1. This document deals with hazards, hazardous situations and hazardous events (see Annex B) relevant to these machines when they are used as intended or under conditions of misuse reasonably foreseeable by the manufacturer. For utility/service/support machines, this…

Le présent document spécifie les exigences de sécurité pour les engins mobiles automoteurs utilisés pour l'exploitation minière souterraine, comme défini en 3.1. Le présent document traite des phénomènes dangereux, des situations dangereuses et des évènements dangereux lorsque les engins sont utilisés comme prévu ou dans des conditions de mauvais usage raisonnablement prévisibles par le…

IEC 60404-9:2018 specifies the measurement and test methods for the determination of the following geometrical characteristics of electrical steel strip and sheet: – edge wave (wave factor); – residual curvature; – edge camber; – deviation from the shearing line (internal stress); – burr height. This document applies to electrical steel strip and sheet intended for the…