Sterilization of health-care products — Ethylene oxide — Requirements for the development, validatio...
ISO 11135:2014 specifies requirements for the development, validation and routine control of an ethylene oxide sterilization process for medical devices in both the industrial and health care facility settings, and it acknowledges the similarities and differences between the two applications.
Acoustics — Hearing aid fitting management (HAFM) — Part 1: General process
This document applies to hearing aid fitting management (HAFM) services offered by hearing aid professionals (HAP) when providing benefit for their clients. The provision of hearing aids relies on the knowledge and practices of a hearing aid professional, to ensure the proper fitting and adequate service in the interest of the client with hearing loss.
This document specifies general processes of…
Plastiques — Détermination des caractéristiques au choc Charpy — Partie 1: Essai de choc non instrum...
Le présent document spécifie une méthode de détermination de la résistance au choc Charpy des plastiques dans des conditions définies. De nombreux types d’éprouvettes et de configurations d’essai différents sont définis. Divers paramètres d’essai sont spécifiés selon le type de matière, le type d’éprouvette et le type d’entaille.
La présente méthode peut être utilisée pour l’étude du comportement…
Systèmes de distribution de gaz médicaux — Partie 1: Systèmes de distribution de gaz médicaux compri...
ISO 7396-1:2016 spécifie les exigences relatives à la conception, à l'installation, au fonctionnement, aux performances, aux essais, à la réception et à la documentation des systèmes de distribution utilisés dans les établissements de soins pour les gaz suivants:
- l'oxygène;
- le protoxyde d'azote;
- l'air médical;
- le dioxyde de carbone;
- les mélanges d'oxygène et de…
Plastics piping systems for pressure and non-pressure water supply, drainage or sewerage — Glass-rei...
ISO 25780:2011 specifies the properties of the piping system and its components made from glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) for water supply, irrigation, drainage or sewerage systems with or without pressure.
ISO 25780:2011 is applicable to GRP-UP piping systems, with flexible joints, intended to be installed using jacking techniques. It…
Information technology — Dynamic adaptive streaming over HTTP (DASH) — Part 8: Session-based DASH op...
This document specifies the format of the Session-Based Description document and the MPD's extension to be used in session-based operations with MPEG DASH (ISO/IEC 23009-1).
Information technology — Cloud computing — Edge computing landscape
This document examines the concept of edge computing, its relationship to cloud computing and IoT, and the technologies that are key to the implementation of edge computing. This document explores the following topics with respect to edge computing:
— concept of edge computing systems;
— architectural foundation of edge computing;
— edge computing terminology;
— software classifications in edge…
Resilient, textile, laminate and modular mechanical locked floor coverings — Castor chair test
ISO 4918:2016 specifies methods for determining the change of appearance and stability of a textile floor covering or any damage caused by detachment of layers, opening of joints, or crazing of a resilient or laminate floor covering under the movement of a castor chair.
Assembly tools for screws and nuts — Hand torque tools — Part 2: Requirements for calibration and de...
This document specifies the method for the calibration of hand torque tools and describes the method of calculation of measurement uncertainties for the calibration.
It also specifies the minimum requirements for a certificate of calibration to this standard for hand torque tools.
The Annex C of this document specifies the minimum requirements for the calibration of the torque measurement device…
