Cycles — Cotter pin and assembly of the axle/cotter pin/crank
Specifies the dimensions and tolerances of the cotter pin and the assembly of the axle/cotter pin/crank. Applies to the fastening of the pedal on the pedal axle.
Plain bearings — Requirements on backings for thick-walled multilayer bearings
Serves as a guide to obtain the optimum bond between backing and bearing metal for thick-walled multilayer plain bearings. This optimum bond depends on the chemical composition, the state of stress, the structural arrangement, and the machining of the bond surface of the backings.
General method for determination of silicon content — Reduced molybdosilicate spectrophotometric met...
Specifies a method based on the depolymerization of any polymerized silica by treatment with sodium fluoride in the presence of hydrochloride acid resulting in the formation of the oxidized molycdosilicate, followed by the selective reduction of this complex in the presence of oxalic acid and in a sulphuric acid medium, and spectrophotometric measurement of the blue-coloured complex at the…
Applies to all kinds of pulp delivered in bales or rolls, and is recommended for use when sampling for all kinds of testing purposes except for the determination of saleable mass. If the pulp is to be tested for saleable mass, in addition to other properties, the gross sample obtained according to the appropriate International Standard for sampling saleable mass may also be used for the other…
These products are similar to petroleum products; many sampling procedures used for petroleum products are equally applicable to the former. Specifies the obtaining of samples from fixed tanks, railcars, road vehicles, barges and drums and from liquids being pumped in pipelines. The samples are intended to be used determine quality, for testing whether contaminants are present and for the…
Industrial wheels for non-powered equipment — Dimensions and nominal load capacities
Specifies the definition of nominal load capacity, the classification of wheels, the specification of wheels, the determination of the category and selection of a wheel and the inspection conditions of industrial wheels and castors. An Annex gives nominal load capacities.
This second edition cancels and replaces the first edition (i. e. ISO 2080:1973). Includes terms widely used in the science and industry of elektrodeposition and metal- finishing. In addition to terms used in the three official ISO languages (English, French and Russian), this International Standard includes the equivalent terms in the German language.Elektrolytisches Herstellen von…
Ethanol for industrial use — Methods of test — Part 6: Test for miscibility with water
The principle of the procedure consists in addition of water to a test portion, under specified conditions, and examination for opalescence against a black background with side illumination, using a second Nessler cylinder containing water as the standard. - International Standards ISO 1388/1 to ISO 1377/12 cancel and replace ISO Recommendation R 1388-1970 of which they constitute a technical…
Ethanol for industrial use — Methods of test — Part 7: Determination of methanol content (methanol c...
The principle is based on the conversion of methanol present in a test portion to formaldehyde by oxidation. The oxidation is carried out with a solution of potassium permanganate in phosphoric acid. Reaction of the formaldehyde formed with chromotropic acid (4,5-dihydroxynaphthalene-2,7-disulphonic acid). Photometric measurement of the violet coloration obtained at a wavelength of about 570 nm…
