Paper and board — Determination of CIE whiteness, D65/10 degrees (outdoor daylight)
ISO 11475:2017 specifies the procedure to be used for determining the whiteness of papers and boards. The values obtained correspond to the visual appearance of white papers and boards with or without fluorescent whitening agents when they are viewed under the CIE D65 daylight standard illuminant. It is based on reflectance data obtained over the full visible spectral range (VIS) in contrast to…
Médecine bucco-dentaire — Fraises de laboratoire — Partie 3: Fraises de laboratoire en carbure pour ...
ISO 7787-3:2017 spécifie des exigences dimensionnelles ainsi que d'autres exigences applicables aux trois fraises en carbure pour machine à fraiser les plus communément utilisées, destinées principalement à un usage en laboratoire dentaire.
Les autres caractéristiques des fraises de laboratoire (par exemple, pour les fraises à denture spiralée ou à tronçonner) ne sont pas traitées dans le…
ISO 19715:2017 specifies requirements and test methods for a filling instrument with contra angle, which is used for the restoration of teeth via the application of polymer-based restorative materials and cements. It also specifies requirements for the design, dimensions and marking.
Pâtes, papier et carton — Dosage du chlore total et du chlore lié aux matières organiques
L'ISO 11480:2017 spécifie deux modes opératoires possibles pour le dosage du chlore total et du chlore organique contenus dans les pâtes, papiers et cartons. Il est applicable à tous les types de pâtes, papiers et cartons. La limite inférieure de dosage est d'environ 20 mg/kg.
Pulp, paper and board — Determination of total chlorine and organically bound chlorine
ISO 11480:2017 specifies two alternative procedures for the determination of total and organically bound chlorine in pulp, paper and board. It is applicable to all types of pulp, paper and board. The lower limit of the determination is about 20 mg/kg.
Dentistry — Shanks for rotary and oscillating instruments
ISO 1797:2017 specifies the requirements for dimensions and material properties of shanks used in dentistry for rotary or oscillating instruments. It describes the measurement methods for the verification of the requirements.
ISO 1797:2017 is not applicable to tips fixed to the handpiece with a screw, e.g. scaler tips.
Information about the location of marking is also given. Annex A on quality…
Seringues hypodermiques stériles, non réutilisables — Partie 1: Seringues pour utilisation manuelle
ISO 7886-1:2017 fixe les exigences et les méthodes d'essai relatives à la vérification de la conception des seringues hypodermiques stériles non réutilisables vides, avec ou sans aiguille, constituées de matières plastiques ou d'autres matières et destinées à l'aspiration et à l'injection de liquides après remplissage par les utilisateurs finaux. Le présent document ne…
Sterile hypodermic syringes for single use — Part 1: Syringes for manual use
ISO 7886-1:2017 specifies requirements and test methods for verifying the design of empty sterile single-use hypodermic syringes, with or without needle, made of plastic or other materials and intended for the aspiration and injection of fluids after filling by the end-users. This document does not provide requirements for lot release. The syringes are primarily for use in humans.
Sterile…
Practice for use of a ceric-cerous sulfate dosimetry system
1.1 This practice covers the preparation, testing, and procedure for using the ceric-cerous sulfate dosimetry system to measure absorbed dose to water when exposed to ionizing radiation. The system consists of a dosimeter and appropriate analytical instrumentation. For simplicity, the system will be referred to as the ceric-cerous system. The ceric-cerous dosimeter is classified as a type 1…
