Radiological protection — Measurement for the clearance of waste contaminated with radioisotopes for...
This document establishes a method for radioactivity measurement and determination of the storage periods of the radioactive wastes produced as a result of the medical application of radioisotopes based on counting measurements using a detector and decay correction of the initial activity concentration of the radioisotopes contained in the waste stream.
It provides a set of controls and…
Road vehicles — Liquefied natural gas (LNG) fuel systems — Part 1: Safety requirements
This document specifies the minimum safety requirements applicable to liquefied natural gas (LNG) on-board fuel system intended for use on the types of motor vehicles defined in ISO 3833.
This document is applicable to vehicles (mono-fuel, bi-fuel or dual-fuel applications) using liquefied natural gas in accordance with the ISO 15403 series. It is not applicable to original-production and…
Road vehicles — Liquefied natural gas (LNG) fuel systems — Part 2: Test methods
This document specifies performance and general test methods for liquefied natural gas fuel system components intended for use on the types of motor vehicles defined in ISO 3833.
This document is applicable to vehicles (mono-fuel, bi-fuel or dual-fuel applications) using liquefied gas in accordance with the ISO 15403 series. It is not applicable to the following: original-production and converted…
Matériaux polymères alvéolaires souples — Détermination de la résilience par rebondissement d'u...
Le présent document spécifie une méthode d'essai utilisant le rebondissement d'une bille pour déterminer la résilience de matériaux polymères alvéolaires souples.
Conducting and dissipative rubbers, vulcanized or thermoplastic — Measurement of resistivity
This document specifies the requirements for the laboratory testing of the volume resistivity of specially prepared test pieces of vulcanized or thermoplastic rubber compounds rendered conducting or dissipative by the inclusion of carbon black or ionizable materials. The tests are suitable for materials with a resistivity of less than about 108 Ω⋅m.
Method 1 is the preferred method when test…
Ships and marine technology — Specification of high manganese austenitic steel used for LNG tanks on...
This document describes the specification of high manganese (Mn) austenitic steel plates to be used for LNG tanks on board ships.
The specification of high manganese austenitic steel can be also considered for design and manufacture of cargo tanks and process pressure vessels of LNG supply/terminal and transportation of fuels and traded gases.
This document is primarily applicable for the…
Fine ceramics (advanced ceramics, advanced technical ceramics) — Test method for fracture toughness ...
This document describes a test method for the determination of the fracture toughness of monolithic ceramic thin plates at room temperature by the single-edge precracked plate method or the single-edge V-notch plate method.
This document is intended for use with monolithic ceramics and whisker- or particulate-reinforced ceramics which are regarded as macroscopically homogeneous. It does not…
Extracorporeal systems for blood purification — Part 3: Plasmafilters
This document specifies requirements and acceptance criteria (including test methods) for safety related parameters for plasmafilters. Only those requirements that are specific to plasmafilters have been included.
It specifies requirements for sterile, single-use plasmafilters, intended for use on humans.
This document does not cover matters related to toxicity. Such issues are covered in…
Graphic technology — Use of PDF to associate processing steps and content data — Part 1: Processing ...
This document describes a method for storing data in a PDF file that correspond to the processing steps of printed products. This method has three parts:
1) metadata identifying processing steps;
2) limitations on the interaction between PDF graphics objects that are part of a processing step and other PDF graphics objects;
3) limitations on PDF graphics objects in processing steps.…
