Information technology — MPEG systems technologies — Part 14: Partial file format
This document specifies the partial file format, which is a generic format for describing file partially received over lossy communication channels. This format contains the correctly received data, missing block identification, and repair information such as location of the file or high-level original indexing information. This format can be used with any file formats, and provides additional…
Road vehicles — Component test methods for electrical disturbances from narrowband radiated electrom...
This document specifies an absorber-lined shielded enclosure method for testing the immunity (off-vehicle radiation source) of electronic components for passenger cars and commercial vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor). The device under test (DUT), together with the wiring harness (prototype or standard test harness), is…
This document deals with diamond tools whose cutting edges are made of CVD diamond, either as a solid single piece or as a coating. The tool specifications are differentiated into CVD diamond-coated tools (CVD diamond thin-film coatings) and tools with a CVD diamond cutting insert.
According to ISO 513, CVD diamond tools can be classified under "hard coatings of hard metal and ceramic"…
Metallic and other inorganic coatings — Measurement of mass per unit area — Review of gravimetric an...
This document gives guidelines for determining the average surface density over a measured area of anodic oxide or of a coating deposited autocatalytically, mechanically, by chemical conversion, by electrodeposition, by hot dip galvanizing and by chemical or physical vapour deposition using gravimetric and other chemical analysis procedures that have attained some degree of national or…
Road vehicles — Vehicle dynamics test methods — Part 1: General conditions for passenger cars
This document specifies the general conditions that apply when vehicle dynamics properties are determined according to ISO test methods.
In particular, it specifies general conditions for:
— variables;
— measuring equipment and data processing;
— environment (test track and wind velocity);
— test vehicle preparation (tuning and loading);
— initial…
Environmental management for concrete and concrete structures — Part 8: Environmental labels and dec...
This document provides a general principle, procedures and requirements for environmental labels and declarations for concrete and concrete structures. It is used for the environmental labels and declarations for concrete constituents, reinforcement, concrete, concrete products and concrete structures.
NOTE This document contains more specific requirements for environmental labels and…
Gas cylinders — Flexible hoses assemblies — Specification and testing
This document provides specification and testing requirements for high pressure flexible hose assemblies intended to be connected to gas cylinders, bundles of cylinders or trailers (battery vehicles), and MEGCs for use when filling and emptying gas at production sites and also for customer use. This document applies to flexible hose assemblies with rated pressures up to 1 000 bar for use in the…
Prefilled syringes — Part 6: Plastic barrels for injectables and sterilized subassembled syringes re...
This document specifies materials, dimensions, quality, and performance requirements, as well as test methods for polymer barrels and sterilized subassembled syringes ready for filling, intended for single use only.
This document also specifies those components that are part of the sterilized subassembled syringe ready for filling.
Polymer barrels and sterilized subassembled syringes ready for…
