Matériel de protection des cultures — Pulvérisateurs à dos — Partie 2: Méthodes d'essai
L'ISO 19932-2:2013 spécifie des méthodes d'essai pour la vérification des exigences de l'ISO 19932‑1 relatives aux pulvérisateurs à dos destinés à être utilisés avec des produits de protection des cultures et que l'opérateur porte sur le dos ou l'épaule.
Elle est applicable aux pulvérisateurs à dos à pression entretenue, aux pulvérisateurs à dos à pression préalable et…
Information security, cybersecurity and privacy protection — Privacy information management systems ...
This document specifies requirements for establishing, implementing, maintaining and continually improving a privacy information management system (PIMS).
Guidance is provided to assist in the implementation of the controls in this document.
This document is intended for PII controllers and PII processors holding responsibility and accountability for PII processing.
This document is applicable to…
Protective gloves against dangerous chemicals and micro-organisms — Part 6: Protective gloves for ha...
This document specifies the requirements for protective gloves to protect the hairdressers, especially the risk against micro-organisms and dangerous chemicals, and defines terms to be used.
Small bore connectors for liquids and gases in healthcare applications — Part 6: Connectors for neur...
ISO 80369-6:2016 specifies requirements for small-bore connectors intended to be used for connections in neuraxial applications. Neuraxial applications involve the use of medical devices intended to administer medications to neuraxial sites, wound infiltration anaesthesia delivery, and other regional anaesthesia procedures or to monitor or remove cerebro-spinal fluid for therapeutic or diagnostic…
Gas cylinders — Cylinders and tubes of composite construction — Modal acoustic emission (MAE) testin...
This document describes the use of modal acoustic emission (MAE) testing during periodic inspection and testing of hoop wrapped and fully wrapped composite transportable gas cylinders and tubes, with aluminium-alloy, steel or non-metallic liners construction, intended for compressed and liquefied gases under pressure.
This document addresses the periodic inspection and testing of composite…
Raccords de petite taille pour liquides et gaz utilisés dans le domaine de la santé — Partie 6: Racc...
L'ISO 80369-6:2016 spécifie les exigences relatives aux raccords de petite taille destinés à être utilisés pour effectuer des raccordements dans des applications neuraxiales. Les applications neuraxiales impliquent l'utilisation de dispositifs médicaux destinés à l'administration de médicaments au niveau de sites neuraxiaux, à l'administration d'anesthésiques pour l'…
Energy audits — Part 3: Guidance for conducting an energy audit using ISO 50002-1 in processes
This document is applicable to carrying out energy audits of a process. It provides guidance on how to apply ISO 50002-1 to an industrial, manufacturing or other process. It should be applied in conjunction with, and is supplementary to, ISO 50002-1, Energy audits — Part 1: General requirements with guidance for use.
Implants for surgery — Components for partial and total knee joint prostheses — Part 2: Articulating...
ISO 7207-2:2011 specifies surface finish requirements for the articulating surfaces of total and partial knee joint prostheses classified in ISO 7207-1.
ISO 7207-2:2011 is intended to provide guidance for periodic validation of production processes.
This document specifies the general characteristics of grooved pins, made of steel and stainless steel, with nominal diameters 1 mm to 25 mm.
These grooved pins are designed to fulfil the main following functions:
— locking of two (or more) parts,
— positioning or guiding,
— relative rotation of the assembled parts.
