This document describes the principles and methods for the expression of results of performance tests on sizing equipment used in coal preparation, and includes methods for the evaluation of performance parameters. Performance test procedures and size measurement techniques are recommended.
This document applies to all types of sizing equipment, categorized as follows:
— screens;
— classifiers…
Hardware for furniture — Strength and durability of hinges and their components — Stays and hinges p...
This document specifies test methods and requirements for the strength and durability of all types of stays and hinges pivoting on a horizontal axis and their components for all fields of application.
The tests consist of the application of loads, forces and velocities simulating normal functional use, as well as misuse, that might reasonably be expected to occur.
With the exception of the…
Horology — Harmonized practices to demonstrate wrist-watches chemical regulatory compliance
This document proposes standardized best practices that would assist stakeholders to demonstrate
chemical compliance of their wrist-watches, according to worldwide products regulations and trade
practices.
It provides an efficient rule of application for regulators who sets up new regulations.
Rubber and plastics hose assemblies and tubing assemblies — Determination of gas-leakage by assembly...
This document specifies the method for the determination of the volume of gas-leakage from the interface between hose and fitting or interface between tubing and fitting by assembly fault.
Explanation of leakage determined by the test method in this document is provided in Annex A. Conception of leakage is shown in Figure A.1 and A.2.
Fans — Determination of fan sound power levels under standardized laboratory conditions — Part 3: En...
ISO 13347-3:2004 applies to industrial fans as defined in ISO 5801 and ISO 13349. It is limited to the determination of airborne sound emission for the specified set-ups. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined.
The sizes of fan which can be tested in accordance with ISO 13347-3:2004 are limited only by the practical aspects of…
Biotechnology — Cell viability analytical methods — Part 1: General requirements and considerations
This document specifies definitions and general requirements for cell viability analytical methods. It provides general considerations for selecting and establishing fit-for-purpose cell viability analytical methods. It also provides considerations for managing sources of variability for cell viability measurements during pre-analytical, analytical, and post-analytical phases.
This document is…
Sustainable mobility and transportation — Automated mobility using physical and digital infrastructu...
This document describes a basic role model of smart city automated mobility services as a common platform for smart city instantiation. It provides a paradigm describing:
a) a framework architecture for the provision of an automated mobility service
b) a description of the concept of operations, and the role models
c) a conceptual architecture between actors involved in the provision/…
Mining and earth-moving machinery — Rock drill rigs and rock reinforcement rigs — Safety requirement...
This document specifies the safety requirements for rock drill rigs and rock reinforcement rigs designed for the following underground or surface operations:
a) blast hole drilling;
b) rock reinforcement;
c) drilling for secondary breaking;
d) dimensional stone drilling;
e) mineral prospecting, e.g. utilizing core drilling or reverse circulation;
f) water and methane drainage drilling;
g) raise…
