Rechercher

1.1 This Standard specifies requirements for copper and aluminum conductor secondary and service- entrance cables intended for use on systems having a nominal voltage of 600 V or less in underground installation a) by direct...

1.1 This Standard applies to permanent adhesive labels and nameplates intended for use indoors or outdoors on application surfaces that are essentially clean, smooth, flat, or simple curved.* * See Annex A 1.2 This Standard...

1.1 This Standard specifies requirements for evaluating adhesives used to bond solid wood materials in structural wood products intended for limited moisture exposure applications. Note: See Annex D for additional information...

1.1 This Standard covers asphalt roofing shingles composed of saturated organic felt or impregnated glass felt, coated on both sides with asphaltic material and surfaced on the weather side with mineral granules. This...

1.1 This Standard applies to single-phase electric tools of the bench type that are intended for use in nonhazardous locations in accordance with the Canadian Electrical Code, Part I, that are connected to a nominal system...

1.1 This Standard specifies the requirements, criteria, and methods of analysis for (a) determining the design response spectra and ground motion time-histories to be used in the analysis; (b) establishing design criteria for...

1.1 This Standard specifies minimum design and material requirements as well as manufacturing practices and markings for prefabricated septic tanks, sewage holding tanks, and effluent chambers made of steel, concrete...

1.1 This Standard covers component assembly surge protective devices (SPDs) consisting of two or more Type 5 components, intended for use in Type 1, 2, or 3 SPD applications. 1.2 Type 4 component assemblies are designed for...

1.1 This Standard covers the requirements for dead-end/suspension composite insulators used on overhead distribution lines operating at nominal voltages up to and including 75 kV. Dead-end insulators support the line...

1.1 This Standard specifies requirements for single- and multi-conductor insulated cables having metallic interlocked armour without an overall jacket (Type AC90 or ACG90) or with an overall jacket (Type ACWU90 or ACGWU90)...

Scope This International Standard specifies methods of measurement of electrical power consumption in standby mode(s) and other low power modes (off mode and network mode), as applicable. It is applicable to electrical...

1.1 This Standard applies to high density polyethylene (HDPE) conduit, HDPE conduit with conductors, and fittings, intended for use at a continuous operating temperature of 75 °C or 90 °C, for installation in accordance with...