Rechercher

1.1 These requirements cover flatiron and appliance plugs intended for use on cord-connected portable cooking or heating appliances rated up to 20 A, 250 Volts or less, intended for use in ordinary non-hazardous locations -...

Note : L’OEN responsable a retiré cet avis d’intention le 2 février 2022. 1.1 1.1.1 This Standard establishes requirements for the planning, design, implementation, maintenance, evaluation, and continual improvement of...

Objet La présente norme établit les exigences minimales pour la planification, la réalisation et la communication des résultats d’études géotechniques pour les fondations de bâtiments dans les zones de pergélisol. La présente...

This part of IEC 61000 defines test methods for immunity to ripple at the d.c. input power port of electrical or electronic equipment. This part of IEC 61000-4 defines the methods for measurement and interpretation of results...

This part of IEC 61000 specifies the immunity requirements, test methods, and range of recommended test levels for equipment subjected to impulse magnetic disturbances mainly encountered in: – industrial installations, –...

1.1 Facilities and workplaces impacted This Standard identifies the requirements for a PSM system for facilities and worksites handling or storing materials that are potentially hazardous, either due to an inherent chemical...

This part of IEC 61000 is concerned with conducted disturbances in the frequency range from 0 kHz to 9 kHz. It gives numerical compatibility levels for industrial and non-public power distribution systems at nominal voltages...

This part of IEC 61000 provides guidance on principles which can be used as the basis for determining the requirements for the connection of unbalanced installations (i.e. three-phase installations causing voltage unbalance)...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to transportable table saws with – a toothed single blade; or – stacked blades that cut a single groove or slot; or – a moulding...

1.1 These requirements are intended to cover both self-ballasted lamps and self-ballasted lamp adapters rated 120 to 347 V AC nominal for connection to screw-base, pin-base, or recessed single contact (RSC or R7) lampholders...

Scope: This document applies to carbon dioxide (CO2) that is injected in enhanced recovery operations for oil and other hydrocarbons (CO2-EOR) for which quantification of CO2 that is safely stored long-term in association...

1.1 This Standard applies to switching and metering centres (hereafter may be referred to for convenience as metering centres or centres) rated 600 V and less, intended to be used in accordance with the Rules of the Canadian...