Rechercher

1.1 Scope 1.1.1 Equipment included in scope This part of IEC 61010 specifies general safety requirements for the following types of electrical equipment and their accessories, wherever they are intended to be used. a)...

1.1 Purpose This document specifies requirements for an IT asset management system within the context of the organization. This document can be applied to all types of IT assets and by all types and sizes of organizations...

Z241.0-03 - Definitions and General Safety Requirements for Park Model Trailers 1. Scope This Standard provides the definition of the term "park model trailer" as used in the CSA Z241 Series. It also gives general safety...

NOTE: Due to an oversight by the responsible SDO, the Notice of Intent (NOI) for CSA/ANSI NGV 6.1 was not registered as required. The NSC has since been published in March 2018. In order to respect the approved parameters of...

Scope This part of ISO/IEC 11179 restates and elaborates on the procedures and techniques of ISO/IEC 11179-3:2003 for registering classification schemes and classifying administered items in an MDR. All types of administered...

Subclause 1.1 of IEC 60601-1:2005, Clause 1 is replaced by: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of a VENTILATOR in combination with its ACCESSORIES, hereafter referred to as ME...

This International Standard defines the following. - A reference comparison method. This method is applicable to two character strings to determine their collating order in a sorted list. The method can be applied to strings...

1.1 This Standard describes testing procedures and states performance requirements for general service incandescent and tungsten halogen reflector lamps. 1.2 This Standard includes performance requirements for (a) wattage; (b...

1.1 Purpose The purpose of this Standard is to establish criteria for the design, manufacture, testing, inspection, installation, maintenance, use, and operation of vehicle-mounted aerial devices installed on a chassis...

1.1 This Standard covers mechanical couplings that are used to axially join pipes and fittings in non-pressure drain, waste, and vent (DWV) piping systems and sewer piping systems located inside or outside buildings and above...

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric HEAT PUMPS, including SANITARY HOT WATER HEAT PUMPS, AIR-CONDITIONERS, and DEHUMIDIFIERS incorporating motor...

This part of ISO/IEC 12087 establishes the specification of the Basic Image Interchange Format (BIIF) part of the standard. BIIF is a standard developed to provide a foundation for interoperability in the interchange of...