Rechercher

1.1 This Standard specifies construction and testing requirements for unarmoured mine power feeder cables normally used for power distribution in stationary or semi-stationary applications covered by CSA M421 and the Canadian...

1.1 This Standard applies to flat cable systems for indoor use, in non-hazardous locations, intended for installation on branch circuits of not more than 600 V 30 A ac between conductors in accordance with CSA C22.1, Canadian...

1.1 This Standard sets out requirements for spacers and/or holding chambers (S-HCs) for use with pressurized metered-dose inhalers. It stipulates the material and components, the packaging and labelling, and aerosol...

1.1 This Standard covers socket- and saddle-type polyethylene (PE) electrofusion fittings that are used to join PE pipe where the heat source is an integral part of the fitting. Note: Fittings covered by this Standard are...

This Technical Specification provides the requirements and a structure for a data documentation format, to be used for transparent and unambiguous documentation and exchange of Life Cycle Assessment (LCA) and Life Cycle...

This Recommendation | International Standard specifies two Versions of a mapping from any XSD Schema into an ASN.1 schema. The ASN.1 schema for both Versions support the same semantics and validate the same set of XML...

1.1 Statement of scope This part of ISO/IEC 11179 defines the type of information to be specified, the conditions to be met, and the procedure(s) to be followed for each metadata item to be registered in a metadata registry...

This part of ISO/IEC 11889 defines the architectural elements of the Trusted Platform Module (TPM), a device which enables trust in computing platforms in general. Some TPM concepts are explained adequately in the context of...

This part of ISO/IEC 11889 contains the definitions of the Trusted Platform Module (TPM) commands. These commands make use of the constants, flags, structures, and union definitions defined in ISO/IEC 11889-2. The detailed...

This part of ISO/IEC 11889 contains C code that describes the algorithms and methods used by the command code in ISO/IEC 11889-3. The code in this part of ISO/IEC 11889 augments ISO/IEC 11889-2 and ISO/IEC 11889-3 to provide...

This part of IEC 61000-4 defines the methods for measurement and interpretation of results for power quality parameters in a.c. power supply systems with a declared fundamental frequency of 50 Hz or 60 Hz. Measurement methods...

1.1 This Standard covers polyethylene (PE) pipe, tubing, and fittings for use in potable cold water supply services or other applications such as water-based ground source geothermal systems. 1.2 This Standard specifies...