Rechercher

This part of IEC 61496 specifies general requirements for the design, construction and testing of electro-sensitive protective equipment (ESPE) for the safeguarding of machinery. Special attention is directed to functional...

This Standard will become a NSC 1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed...

Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of INFANT TRANSPORT INCUBATOR equipment, as defined in 201.3.211 of this standard, also referred to as ME EQUIPMENT. If a clause...

Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of X-RAY EQUIPMENT declared by the MANUFACTURER to be suitable for RADIOSCOPICALLY GUIDED INTERVENTIONAL PROCEDURES, hereafter...

1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed This Standard specifies...

Note: Scope updated August 28, 2018 as per a request from the responsible SDO. (NOI originally published to CNS on April 17, 2017) This Standard gives minimum requirements for ventilators used in buildings which are designed...

Introduction to the Guideline Infrastructure in the North commonly depends on permafrost for its foundation material. Such infrastructure should be designed with full consideration for the potential of climate change...

This International Standard specifies the signalling protocol for the support of the Short Message Service (SMS) at the Q reference point between Private Integrated services Network eXchanges (PINXs) connected together within...

1.1 This Standard applies to the selection of materials for, and the fabrication and installation of, permanent wood foundations. 1.2 Specific details are provided for buildings up to three storeys in building height above...

This part of ISO/IEC 14543 establishes general principles for network and device management shared by all installation modes for network based control of HES Class 1 and independent of the installation mode used. The aim is...

This standard is concerned with conducted disturbances in the frequency range from 0 kHz to 9 kHz, with an extension up to 148,5 kHz specifically for mains signalling systems. It gives compatibility levels for public low...

This part of IEC 61000 is concerned with conducted disturbances in the frequency range from 0 kHz to 9 kHz, with an extension up to 148,5 kHz specifically for mains signalling systems. It gives compatibility levels for public...