Rechercher

These requirements cover fuseholders intended for use with Class G Fuses as described in NMX-J-009/248/5-2000-ANCE, CSA C22.2 No. 248.5, UL 248-5, Low-Voltage Fuses - Part 5: Class G Fuses.

This Technical Report provides guidance on the development of content for, and consistency in, the communication of information on safety, health and environmental matters in safety data sheets (SDS) for substances classified...

This Code sets out the minimum provisions for the installation, extension, alteration, and renewal of hydronic heating systems. This Code applies to open and closed hydronic heating systems. These systems include a) hydronic...

1.1 The provisions of this Standard, forming a part of the Canadian Electrical Code, Part III, embody the applicable principles and general practices where underground metallic structures are subject to the risk of electro...

The scope of this project is to develop a slurry pumping system energy standard referencing actual energy usage versus essential energy required. The standard will be used to assess energy usage of slurry pumping systems...

This Standard describes the general requirements for compressor packages used in compressed natural gas fueling station service.

Cette norme proposée vise à mettre en place un minimum de contrôles de cybersécurité pour les petites et moyennes organisations.

ISO 9004:2018 gives guidelines for enhancing an organization's ability to achieve sustained success. This guidance is consistent with the quality management principles given in ISO 9000:2015. ISO 9004:2018 provides a self...

The Standard is an adoption with U.S. and Canadian deviations of the identically titled IEC (International Electrotechnical Commission) Standard 62282-3-100 (second edition, 2019-02). The Standard applies to stationary...

CSA W209 Biomass Supply Chain Risk will cover requirements and guidance regarding potential risks to biomass supply chains, including the following risk categories: Supplier Risk Competitor Risk Supply Chain Risk Feedstock...

ISO 11135:2014 specifies requirements for the development, validation and routine control of an ethylene oxide sterilization process for medical devices in both the industrial and health care facility settings, and it...

ISO 14161:2009 provides guidance for the selection, use and interpretation of results from application of biological indicators when used in the development, validation and routine monitoring of sterilization processes. This...