Rechercher

1.1 This Standard specifies procedures for 24 h simulated-use testing of gas-fired instantaneous water heaters. This Standard also provides calculations for the determination of (a) the maximum L/min (gpm) rating; (b)...

Scope 1.1 This Standard sets forth the general requirements for seismic design and qualification of CANDU nuclear power plants. 1.2 This Standard applies to all structures, systems, and components (SSCs) of CANDU nuclear...

Scope 1.1 This Standard addresses issues related to the safety of human tissues used for transplantation. It includes quality system requirements and aspects of safety for potential and actual donors and recipients, personnel...

Scope and object This part of IEC 61730 describes the fundamental construction requirements for photovoltaic (PV) modules in order to provide safe electrical and mechanical operation during their expected lifetime. Specific...

Scope and object This part of IEC 61730 describes the fundamental construction requirements for photovoltaic (PV) modules in order to provide safe electrical and mechanical operation during their expected lifetime. Specific...

Scope This clause of IEC Publication 335-1 is applicable except as follows: 1.1 Replacement: This standard applies to electric fans and their associated regulators intended for use on single-phase a.c. and d.c. circuits not e...

Scope and object This part of IEC 61730 describes the fundamental construction requirements for photovoltaic (PV) modules in order to provide safe electrical and mechanical operation during their expected lifetime. Specific...

1.1 These requirements cover permanently installed devices, hereafter referred to as dimmers, that employ a dimming function intended for control of lighting loads of the magnetic ballast, transformer, electronic ballast...

1.1 This Standard applies to equipment for installation and use in accordance with the Rules of the Canadian Electrical Code, Part I, other than conduit couplings. 1.2 This Standard includes basic construction and inspection...

1.1 General This Standard provides requirements for the design and evaluation of building components of fibre-reinforced polymers (FRP) in buildings and of building components reinforced with FRP materials. It is based on...

1.1 This Standard covers assemblies of wiring terminals and supporting blocks for copper conductors, copper and aluminum conductors, and aluminum conductors rated at a maximum of 1500 V and 2000 kcmil, intended to provide for...

1.1 This Standard specifies the test methods and marking requirements, and references energy efficiency levels for three-phase induction motors. Note: The test methods contained in this Standard are not limited to specific...