Rechercher

1.1 This Standard applies to rigid PVC (unplasticized) conduit, elbows, bends, and couplings, intended for use at a continuous operating temperature of 75 °C, for the installation of wires and cables in accordance with the...

1.1 This Standard applies to wet-process porcelain and toughened glass suspension-type insulators used on ac overhead power lines with a nominal voltage greater than 1000 V and a frequency not greater than 100 Hz. This...

1.1 This Standard applies to cord-connected, electrically heated warming pads with associated control units, for household and hospital use, to be used in nonhazardous locations, designed for nominal 120 V ac circuits, in...

1.1 This Standard applies to enclosed and dead-front switches for use in photovoltaic (PV) systems rated 1500 V dc maximum, 1200 A maximum. 1.2 Fusible switches for photovoltaic applications are intended for use with...

1.1 This Standard specifies performance requirements and related test procedures for evaluating self-ballasted compact fluorescent lamps (CFLs) and ballasted adapters that are intended for general lighting use with 120 V, 60...

1.1 This Standard specifies performance requirements for torchieres that use non-screw-in (Edison type) lamp bases and are intended primarily for residential use. 1.2 Although this Standard largely deals with fluorescent...

This document defines key establishment mechanisms using symmetric cryptographic techniques. This document addresses three environments for the establishment of keys: Point-to-Point, Key Distribution Centre (KDC), and Key...

1.1 This Standard defines minimum energy efficiency and performance requirements for light emitting diode (LED) lamps with an ANSI or IEC standardized base that are designed to connect to a low-voltage or branch circuit via a...

1.1 This Standard specifies energy performance and marking requirements for suspended and hugger ceiling fans intended to be connected to supply circuits not exceeding 250 V for use in residential and industrial/commercial...

1.1 This Standard applies to airport series lighting cables (Type ASLC) intended for use above and below ground in dry or wet locations in accordance with the Rules of the Canadian Electrical Code, Part I, at a nominal...

1.1 This Standard applies to indoor or outdoor, open or enclosed, shunt power capacitors and assemblies of shunt power capacitors with associated interconnections and supporting structures, for power factor improvement and...

1.1 This Standard applies to enclosed and dead-front switches for use in photovoltaic (PV) systems rated 1500 V dc maximum, 1200 A maximum. 1.2 Fusible switches for photovoltaic applications are intended for use with...