Rechercher

1.1 This Standard covers polyethylene/aluminum/polyethylene (PE-AL-PE) macrocomposite pipe consisting of a welded aluminum tube laminated by a melt adhesive to layers of polyethylene (PE) inside and outside the aluminum tube...

1.1 This Standard covers crosslinked polyethylene/aluminum/crosslinked polyethylene (PEX-AL-PEX) macrocomposite pipe consisting of a welded aluminum (AL) tube laminated by a melt adhesive to layers of crosslinked polyethylene...

1.1 This Standard specifies requirements for crosslinked polyethylene (PEX) tubing systems that comprise tubing and fittings. Tubing covered by this Standard is made in Standard Dimensional Ratio 9 (SDR 9). Systems are...

1.1 This part of ISO 11137 specifies requirements for the development, validation and routine control of a radiation sterilization process for medical devices. NOTE Although the scope of this part of ISO 11137 is limited to...

This part of ISO/IEC 11770 defines key management mechanisms based on asymmetric cryptographic techniques. It specifically addresses the use of asymmetric techniques to achieve the following goals. a) Establish a shared...

This part of ISO/IEC 12087 establishes the specification of the Basic Image Interchange Format (BIIF) part of the standard. BIIF is a standard developed to provide a foundation for interoperability in the interchange of...

This International Standard deals with the safety of electrical appliances for household and similar purposes, their RATED VOLTAGE being not more than 250 V for single-phase appliances and 480 V for other appliances. NOTE 1...

1.1 1.1.1 The requirements specified in this Standard cover light-emitting diode (LED) equipment that is an integral part of a luminaire or other lighting equipment and that operates in the visible light spectrum between 400...

1.1 This Standard applies to newly produced direct gas-fired crop dryers of the recirculating or non-recirculating type, hereinafter referred to as “dryers”, the primary purpose of which is to provide process heating to dry...

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric appliances for the care of skin or hair of persons or animals and intended for household and similar purposes...

1.1 This Standard specifies methods for measuring the volume, energy consumption, and total display area (TDA) of electrically operated commercial refrigeration equipment. 1.2 This Standard applies to commercial refrigerator...

Scope 1.1 This Standard describes the test procedures required to perform a 24 h simulated-use test. This Standard also provides the calculations required to determine the first-hour rating, maximum flow rate, recovery...