Rechercher

This part of IEC 61000 defines the immunity test methods and range of preferred test levels for electrical and electronic equipment connected to low-voltage power supply networks for voltage dips, short interruptions, and...

This part of IEC 61000 defines test methods for immunity to ripple at the d.c. input power port of electrical or electronic equipment. This standard is applicable to low-voltage d.c. power ports of equipment supplied by...

1.1 These requirements cover flatiron and appliance plugs intended for use on cord-connected portable cooking or heating appliances rated up to 20 A, 250 Volts or less, intended for use in ordinary non-hazardous locations -...

Note : L’OEN responsable a retiré cet avis d’intention le 2 février 2022. 1.1 1.1.1 This Standard establishes requirements for the planning, design, implementation, maintenance, evaluation, and continual improvement of...

1.1 This Standard covers the features of three-phase submersible transformers rated 75 to 3000 kV.A. Note: For details not covered herein, reference should be made to CSA C2.1. 1.2 This Standard applies only to three-phase...

1.1 This Standard specifies methods for measuring electrical power consumption of equipment intended for use in commercial and industrial application when in low power mode(s) (i.e., standby mode, off mode, and network mode)...

1.1 This Standard applies to industrial control panels and assemblies rated at not more than 1500 V, intended to be installed and used in non-hazardous locations in accordance with the rules of the Canadian Electrical Code...

1.1 This Standard applies to industrial control panels and assemblies rated at not more than 1500 V, intended to be installed and used in non-hazardous locations in accordance with the rules of the Canadian Electrical Code...

This part of IEC 61000 defines test methods for immunity to ripple at the d.c. input power port of electrical or electronic equipment. This part of IEC 61000-4 defines the methods for measurement and interpretation of results...

This part of IEC 61000 specifies the immunity requirements, test methods, and range of recommended test levels for equipment subjected to impulse magnetic disturbances mainly encountered in: – industrial installations, –...

1.1 Facilities and workplaces impacted This Standard identifies the requirements for a PSM system for facilities and worksites handling or storing materials that are potentially hazardous, either due to an inherent chemical...

This part of IEC 61000 is concerned with conducted disturbances in the frequency range from 0 kHz to 9 kHz. It gives numerical compatibility levels for industrial and non-public power distribution systems at nominal voltages...