Rechercher

1.1 This Standard specifies test procedures and performance requirements for screw-based general service lamps that are designed for an operating capability that partially falls within 100 and 130 V. 1.2 This Standard does...

This Standard covers integral horsepower, three-phase, alternating current, squirrel cage induction motors rated 200 to 13 200V at 60 Hz. This Standard also covers motors operating on variable frequency drives. Note: This...

This standard applies to zinc-coated steel wires used in the construction and/or reinforcement of conductors for overhead power transmission purposes. It is intended to cover all wires used in constructions where the...

1. Scope [Replace this clause with the following] This Standard covers the electrical and mechanical characteristics of round wires of aluminium 1350-H19, having diameters of 1.25 to 6.50 mm, intended for stranding into...

1. Scope This Standard is applicable to aluminium-magnesium-silicon alloy wires of two designations having different mechanical and electrical properties for the manufacture of stranded conductors for overhead power...

This International Standard applies to bare, hard-drawn, round, aluminum-clad wires of different electrical and mechanical properties, in the diameter ranges shown in table 5, for electrical purposes, before stranding. It is...

This part of International Standard IEC 60044 applies to newly manufactured electronic voltage transformers with analogue output, for use with electrical measuring instruments and electrical protective devices at frequencies...

This International Standard specifies a static test method and the acceptance conditions for roll-over protective structures (cab or frame) of wheeled tractors for agriculture and forestry. It is applicable to tractors having...

1.1 This Standard applies to structures and hoists that are not a permanent part of buildings, structures, or other works and that are used during construction, alteration, or demolition to raise and lower materials connected...

1.1 This Standard applies to structures and hoists that are not a permanent part of buildings, structures, or other works, and that are used during construction, alteration, or demolition to raise and lower persons and/or...

1.1 This Standard covers the fire resistance, toxicity, and stability with respect to separation of water-in-oil emulsions of hydraulic fluids intended for use at mines. 1.2 This Standard covers fluid in the following...

1.1 This Standard covers the chemical, mechanical, and dimensional requirements for roof and rock bolts and accessories. Addressed in this Standard are double-end threaded, headed, and slotted steel bars; fully grouted bolts...