Rechercher

1.1 La présente norme prescrit les exigences minimales visant les matériaux utilisés dans la maçonnerie et la mise en oeuvre de la maçonnerie. Notes : 1) Les exigences visant le calcul de la maçonnerie sont prescrites dans la...

This International Standard specifies a uniform representation of human sexes for the interchange of information. It is intended to reduce the time required to record and/or format the representation of sexes and transmit the...

This International Standard specifies generic cabling for homes. A home may contain one or more buildings or may be within a building that contains more than one home. This Standard specifies a generic cabling for three...

1.1 This Standard provides requirements for the design, fabrication, installation, and maintenance of single-membrane structures that are either reinforced or unreinforced and that are air-supported, frame-supported, or cable...

.1.1 These fuseholders and devices accommodate fuses to be employed in electrical circuits and are intended to be used in accordance with the Canadian Electrical Code, Part I (CE Code Part I), CSA C22.1, the National...

1.1.1 These fuseholders and devices accommodate fuses to be employed in electrical circuits and are intended to be used in accordance with the Canadian Electrical Code, Part I (CE Code Part I), CSA C22.1, the National...

1. The Standards for foam liquid concentrates are divided into three categories. Category 1 Primarily for use on general-purpose hydrocarbon fires Category 2 Primarily for use on polar solvents, oxygenated fuels, and water...

La présente norme spécifie les principales caractéristiques des clapets antiretour en thermoplastique ayant un diamètre nominal jusqu’à 200 mm (8 po) ou en fonte ayant un diamètre nominal jusqu’à 375 mm (15 po) et les...

1.1 Purpose The purpose of this Standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2 and Class...

1.1 Introduction 1.1.1 The purpose of this standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2...

1 SCOPE 1.1 These requirements cover emergency breakaway fittings intended only for flammable and combustible liquid service including gasoline with up to 15 % ethanol. 1.2 An emergency breakaway fitting is intended for use...

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric deep fat fryers having a recommended maximum quantity of oil not exceeding 5 l, frying pans, woks and other...