Rechercher

1.1 This Standard defines minimum energy efficiency and performance requirements for light emitting diode (LED) lamps with an ANSI or IEC standardized base that are designed to connect to a low-voltage or branch circuit via a...

1.1 This Standard specifies the test method for measuring the energy performance of displays with a viewable screen size less than 75 cm (30 in) diagonal. Note: This Standard is technology neutral. 1.2 This Standard does not...

This part of IEC 61000 relates to the immunity requirements and test methods for electrical and electronic equipment, under operational conditions, to non-repetitive damped oscillatory transients (ring waves) occurring in low...

1.1 This Standard specifies energy performance and marking requirements for suspended and hugger ceiling fans intended to be connected to supply circuits not exceeding 250 V for use in residential and industrial/commercial...

1.1 This Standard applies to enclosed and dead-front switches for use in photovoltaic (PV) systems rated 1500 V dc maximum, 1200 A maximum. 1.2 Fusible switches for photovoltaic applications are intended for use with...

This document defines key establishment mechanisms using symmetric cryptographic techniques. This document addresses three environments for the establishment of keys: Point-to-Point, Key Distribution Centre (KDC), and Key...

1.1 This Standard applies to indoor or outdoor, open or enclosed, shunt power capacitors and assemblies of shunt power capacitors with associated interconnections and supporting structures, for power factor improvement and...

1.1 This Standard specifies performance requirements for torchieres that use non-screw-in (Edison type) lamp bases and are intended primarily for residential use. 1.2 Although this Standard largely deals with fluorescent...

1.1 This Standard applies to airport series lighting cables (Type ASLC) intended for use above and below ground in dry or wet locations in accordance with the Rules of the Canadian Electrical Code, Part I, at a nominal...

1.1 This Standard applies to cord-connected household and commercial irons of the steam or dry type, with or without automatic temperature control, for voltages of 250 V and less, designed to be used in accordance with the...

1.1 This Standard specifies requirements for covered overhead distribution line wire. These conductors are intended for overhead installation as single conductors on single-phase or three-phase electrical distribution systems...

1.1 This Standard applies to oil-fired forced warm-air heating appliances for installation in mobile housing and recreational vehicles, irrespective of the heating capacity or the type of burner used. 1.2 This Standard...