Rechercher

The primary purpose of ISO/IEC 19788 is to specify metadata elements and their attributes for the description of learning resources. This includes the rules governing the identification of data elements and the specification...

1.1 This Standard applies to exterior bond, all-veneer plywood that has a minimum of three plies and whose outermost plies have parallel grain direction. 1.2 This Standard specifies requirements for (a) a quality system; (b)...

1.1 This Standard specifies requirements for crosslinked polyethylene (PEX) tubing systems that comprise tubing and fittings. Tubing covered by this Standard is made in Standard Dimensional Ratio 9 (SDR 9). Systems are...

The primary purpose of this International Standard is to specify metadata elements and their attributes for the description of learning resources. This includes the rules governing the identification of data elements and the...

1.1 This Standard applies to electric household dishwashers intended to be used in nonhazardous locations in accordance with the Canadian Electrical Code (CEC), Part I, C22.1, General Requirements %u2013 Canadian Electrical...

1.1 This Standard applies to appliance plugs used as components of heater cord sets for use on cord- connected heating appliances rated for use on nominal single-phase system voltages of 240 V and less, designed to be used in...

1.1 This Standard applies to a Type FCC under-carpet wiring system utilizing cable that is installed under carpet squares that are removable, and associated accessories, intended for use in accordance with the Rules of the...

F378.1-11 - Glazed and unglazed liquid heating solar collectors - Test methods Scope 1.1 This Standard specifies a set of technical requirements and test methods for glazed and unglazed liquid heating solar collectors and...

1.1 This Standard applies to suspension and dead-end composite insulators used on ac overhead transmission lines with a nominal voltage greater than 75 kV and a frequency not greater than 100 Hz. 1.2 The objectives of this...

1.1 This Standard specifies the electrical requirements for safe interconnection of inverter-based micro-distributed resource (micro-DR) systems to low-voltage systems connected to distribution systems. The output of these...

1.1.1 This Standard covers CGA 791 (Type I) and CGA 810 (Type II) cylinder connection devices, as defined in Part IV, Definitions, intended to connect the cylinder valve on portable LP-Gas containers to the inlet of the...

1.1 This Standard covers the electrical and mechanical characteristics of (a) round 1350-H19 hard-drawn aluminum wires (A1) before compacting; (b) round zinc-coated hard-drawn steel core wires (S1A); and (c) bare compact...