Rechercher

This Standard covers plumbing fittings, including the following: a) automatic compensating valves other than those for individual wall-mounted showering systems; b) solenoid valves; c) temperature-actuated in-line mixing...

Details test and examination criteria for manually-operated gas valves, not exceeding 4 inches (102 mm) pipe size, and pilot shut-off devices, except for hose end valves and appliance connector valves, intended to be used as...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to screwdrivers and impact wrenches. This standard does not apply to drills that can be used for driving screws by attaching...

The CSA B64 Series covers vacuum breakers and backflow preventers that are used in potable water supply systems to prevent cross-connections

This standard specifies material, design, construction and performance criteria for the testing and rating of grease interceptors equipped with an automatic grease removal device (GRD).

This Standard covers drinking water treatment systems that are Point-of-use or point-of-entry plumbed systems; and Point-of-use non-plumbed systems. The Standard includes electrical requirements for drinking water treatment...

This Standard covers flexible water connectors for use in water supply systems under a) continuous pressure in accessible locations; and b) intermittent pressure in recreational vehicles only.

This Standard specifies requirements for manually operated valves, also known as supply line stops, in sizes NPS 4 and smaller

This Standard covers thermoplastic nonpressure piping, including a) drain, waste, and vent pipe and pipe fittings; b) sewer and storm pipe and pipe fittings; and c) accessories such as factory-assembled expansion joints...

This Standard applies to structures and hoists that are not a permanent part of buildings, structures, or other works, and that are used during construction,alteration, or demolition to raiseand lower persons and/or materials...

The provisions of this standard apply to the design, materials, installation and operation of rainwater harvesting systems for potable and non-potable applications.

1.1.1 The purpose of this standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2 and Class III...