Rechercher

.1 Objective 1.1.1 This Standard contains requirements for reinforced thermosetting resin conduit (RTRC) of the extra heavy wall type (XW) in trade sizes 3/4-6 (metric designators 21-155). 1.1.2 Products covered by this...

1.1 This Standard specifies requirements for single- and multi-conductor insulated cables having metallic interlocked armour without an overall jacket (Type AC90 or ACG90) or with an overall jacket (Type ACWU90 or ACGWU90)...

1.1 This Standard defines minimum energy efficiency and performance requirements for light emitting diode (LED) lamps with an ANSI or IEC standardized base that are designed to connect to a low-voltage or branch circuit via a...

This document specifies requirements for establishing, implementing, maintaining and improving an energy management system (EnMS). The intended outcome is to enable an organization to follow a systematic approach in achieving...

.1 This Standard specifies the test method for measuring the energy performance of displays with a viewable screen size less than 75 cm (30 in) diagonal. Note: This Standard is technology neutral. 1.2 This Standard does not...

1.1 This Standard specifies the energy performance test method for room air conditioners and specifies minimum efficiency levels. 1.2 This Standard covers room air conditioners powered by a single-phase electric current and...

1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, CSA C22.1. 1.2 These...

This part of IEC 61400 presents measurement procedures that enable noise emissions of a wind turbine to be characterised. This involves using measurement methods appropriate to noise emission assessment at locations close to...

This standard provides basic procedures based on joint ultimate load or a limiting slip for the determination of the lateral strength resistance and lateral slip resistance of truss pate teeth embedded in sawn and structural...

This Standard applies to corrugated electrical nonmetallic tubing (ENT) and mechanically- attached fittings, for use in accordance with C22.1, Canadian Electrical Code, Part I (CEC), and NFPA 70, National Electrical Code (NEC...

.1 This Standard specifies the requirements for cord-connected and permanently connected, industrial type heating equipment intended to be used in ordinary locations in accordance with CSA C22.1, Canadian Electrical Code...

1.1 This Standard applies to locking type plugs, receptacles, equipment power inlets and outlets, and connectors rated up to 60 A and up to 600 V ac or 250 V dc, for use in accordance with the Canadian Electrical Code, Part I...