Rechercher

1.1 This Standard specifies requirements for the installation of packaged solar domestic hot water (SDHW) systems that meet the requirements of the CSA F379 Series. Note: SDHW systems include those designed to (a) provide hot...

This part of ISO/IEC 14888 specifies digital signature mechanisms with appendix whose security is based on the discrete logarithm problem. This part of ISO/IEC 14888 provides - a general description of a digital signature...

2.1 Type of Equipment This standard applies to cast resin partitions pressurized with inert gases, eg, sulphur hexafluoride, carbon tetrafluoride, or a mixture of such gases, such as sulphur hexafluoride and nitrogen used in...

This part of ISO/IEC 14888 specifies digital signature mechanisms with appendix whose security is based on the discrete logarithm problem. This part of ISO/IEC 14888 provides - a general description of a digital signature...

1.1 General This Standard specifies requirements for the identification of OHS hazards, their elimination where practical, and assessment and control of risks associated with remaining hazards. 1.2 Applicability This Standard...

.1 This Standard specifies requirements for measuring the thermal efficiency, electric power consumption, and power factor of gas-fired unit heaters with a maximum input rate of 2 931 kW (10 000 000 Btu/h) or less (including...

1.1 This Standard applies to woodlots and small forests up to 4000 hectares that have a management plan; these are termed "defined woodlots" (see Clause 3). It provides sustainable forest management requirements for (a) a...

1.1 This Standard applies to single-conductor and multi-conductor Type RA90 and RC90 cables having a maximum temperature rating of 90 °C in both dry and wet locations and intended for installation in accordance with CSA C22.1...

2.1 Type of Equipment This Standard applies to cast resin partitions pressurized with inert gases, eg, sulphur hexafluoride, carbon tetrafluoride, or a mixture of such gases, such as sulphur hexafluoride and nitrogen used in...

1.1 General This Standard provides rules and requirements for the design, fabrication, and erection of steel structures. The design is based on limit states. The term "steel structures" refers to structural members and frames...

1.1 This Standard covers requirements for devices to detect certain out of parameter conditions of supply voltage and/or load current and mitigate, by circuit interruption, the effects of (a) overload within utilization...

1.1 This Standard sets forth methods for both new installation and replacement installation of factory- assembled windows, exterior doors, and unit skylights that are intended for installation in low-rise buildings and...